Modern Electronics Factory MEF990B User Manual

iSM990BT
Bluetooth
PAIRING button
BLUETOOTH
BLUETOOTH SETUP
1.) Power on the unit by pressing the ON/OFF button.
2.) Press the FUNCTION button to switch to Bluetooth mode. The display will show the flashing letters “bt”.
3.) “ bt “ will flash quickly on the display. When pairing, remain within 3 feet of the unit. If the unit does not automatically begin to pair, press and hold the PAIRING button.
4.) Using the native controls on your Bluetooth device, select the “Singing machine” in your Bluetooth settings to pair. If your device requests a password, enter the default password “0000”. Refer to the user’s manual for your specific device for instructions on pairing and connecting Bluetooth device.
5.) When successfully paired, the display will stop flashing. After initial pairing, the unit will stay paired unless unpaired manually by the user or erased due to a reset of the devices. If your device should become unpaired, follow the above steps again. If any pairing issues should occur, un-pair the unit on your Bluetooth device and follow the above steps again.
PLAYING MUSIC VIA BLUETOOTH
1.) Follow the instructions for Pairing a Bluetooth Device.
2.) Use the native controls on the connected Bluetooth Device to select a track.
3.) To play, pause or skip the selected track, use the native controls on the connected Bluetooth Device or press the PLAY/PAUSE, SKIP button of unit.
4.) Audio played through the connected Bluetooth device now be heard through the speaker.
No sound when playing audio via Bluetooth
Your Bluetooth device has been paired properly. The volume control of your Bluetooth device is set at too low. The volume control of the Bluetooth speaker is set at too low.
Pairing your Bluetooth device according to the " PAIRING YOUR BLUETOOTH DEVICE" section. Increase the volume of your Bluetooth device. Increase the volume of the unit by tune the volume knob to "+".
BLUETOOTH SECTION
SUPPORT A2DP / AVRCP
2.5A
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
  Increase the separation between the equipment and receiver.   Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
  Consult the dealer or an experienced radio/TV technician for help.
Loading...