Modern Electronics Factory 696PP8041 User Manual

MODEL NO.: LP-56U-BT

Instruction Manual

PLEASE READ BEFORE USING THIS EQUIPMENT

1

Important Safety Instructions

1 Read these Instructions.

Keep these Instructions.

2

Heed all Warnings.

3

Follow all instructions.

4

Do not use this apparatus near water.

5

Clean only with a dry cloth.

6

Do not block any ventilation openings. Install in

7

accordance with the manufacturer’s instructions.

8

Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifers) that produce heat.

9

Do not defeat the safety purpose of the polarized or
grounding - type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The wide
blade or the third prong are provided for your safety.
When the provided plug does not ft into your outlet,
consult an electrician for replacement of the obsolete
outlet.

Protect the power cord from being walked on or

10

pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.

11

Only use attachments/accessories specifed by the
manufacturer.

12.

Use only with a cart, stand, tripod,
bracket, or table specifed by the
manufacturer, or sold with the apparatus.
When a cart is used, use caution when
moving the cart/apparatus combination
to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or
when unused for long periods of time.

14. Refer all servicing to qualifed service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord
or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.

FCC Warnings

NOTE: This equipmenthas beentestedand found to comply or has
been dropped.
with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for
help .

Additional Warnings

•

The apparatus shall not be exposed to dripping or splashing and
that no objects flled with liquids, such as vases, shall be placed
on apparatus.

L’appareil ne doit pas être exposé aux écoulements ou aux
éclaboussures et aucun objet ne contenant de liquide, tel qu’un
vase, ne doit être placé sur l’objet.

•

Main plug is used as disconnect device and it should remain readily
operable during intended use. In order to disconnect the apparatus
from the mains completely, the mains plug should be disconnected
form the mains socket outlet completely.

La prise du secteur ne doit pas être obstruée ou doit être facilement
accessible pendant son utilisation. Pour être complètement
déconnecté de l’alimentation d’entrée, la prise doit être débranchée
du secteur.

•

Battery shall not be exposed to excessive heat such as sunshine,
fire or the like.

Les piles ne doivent pas être exposées à de forte chaleur, tel qu’à
la lumière du soleil, au feu ou autres choses de semblable.

•

Caution marking is located at the rear or back of the apparatus.

Attention marquage est situé à l’arrière ou à l’arrière de l’appareil.

•

The marking information is located at the rear or back of apparatus.

Les informations de marquage est situé à l’arrière ou à l’arrière de
l’appareil.

2

TURNTABLE PANEL

4

1

5

2

6
7

8

9

3

1. 45 RPM ADAPTER

2. TURNTABLE

3. CONTROL PANEL

4. TRANSIT SCREW CROSSING

5. LIFT LEVER

6. SPEED SELECTOR (33/45/78 RPM)

7. AUTO STOP CONTROL SWITCH

8. TONE ARM LOCK

9. TONE ARM WITH STYLUS

10. VOLUME DIAL

10

3