Modern Electronics Factory 393MET1426 User Manual

FCC NOTICE:

This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:

l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment and receiver.
l Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

l Consult the dealer or an experienced radio/TV technician for help.

FCC STATEMENT:

This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference

that may cause undesired operation. The antenna(s) used for this
transmitter must be installed to provide a separation distance of at least
20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.

2ANH7-393MET1426

FCC WARNING:

To assure continued operation, follow the attached installation instructions and
use only shield cables when connecting to other devices. Changes or
modifications not expressly approved b y the party responsible for compliance
could void the user's authority to operate the equipment.

1

LOCATION OF CONTROL

FRONT VIEW

TOP VIEW

3

4

1

5

VOLUME

6

SOURCE

LIGHT

LINE IN

STANDBY / AUXIN

7

8

14

13 15

12

10 11

9

2

REAR VIEW

L

R

DC IN

LINE IN

AUX IN

17

16

2

18

LOCATION OF CONTROLS

1. Loud Speakers with LED Decorative Lights

2. Subwoofer with LED Decorative Lights

3. Remote Sensor

4. Cradle (To hold Remote Control/External Audio Player/Cell Phone)

5. DJ Scratching Effect Knob

6. SOURCE Button

7. LIGHT On/Off Button

8. Standby On/Off Button

9. (Skip Backward) Button

10. (Play/Pause) Button

11. (Skip Forward) Button

12. (Bluetooth) Indicator

13. LINE IN Indicator

14. STANDBY/AUX IN Indicator

+

15. VOLUME +/- Buttons

_

16. DC 12V Jack

17. LINE IN (3.5mm Stereo) Jack

18. AUX IN (RCA) Jacks

3