Modern Electronics Factory 3938021BT User Manual
CDG / MP3G KARAOKE PLAYER & BLUETOOTH
MEDIA WITH 7 ” TFT SCREEN
Model: MET8021TFT
User’sGuide
PLEASE READ BEFORE OPERATING THIS EQUIPMENT
FCC Warnings
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
FCC ID: 2ANH7- 3938021BT
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum distance 20
cm between the radiator & your body.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
MAIN UNIT LOCATION CONTROLS 1.1
MAIN UNIT LOCATION CONTROLS 1.2
CONTROLS:
1. SCREEN Button
2. SOURCE Button
3. LIGHT Button
4. KEY CHANGER (KEY- / PAGE- or KEY+/PAGE+) Button
5. NORMAL Button
6. CHARGING Indicator
7. AUX IN Input
8. USB Port For Play Back
9. STANDBY Button
10. RECORD Button
11. RECORD PLAYBACK Button
12. PROG / REPEAT Button
13. STOP Button
14. SKIP/ SEARCH Button
15. / PAIR / PLAY / PAUSE button:
16. DISC DOOR OPEN Button
17. MICROPHONE HOLDER
18. MIC VOL Dial
19. ECHO Dial
20. MIC 1 Inputs
21. DISCO LIGHT
22. CRADLE
23. MASTER VOLUME Dial
24. TFT Display / DISC Door
25. BALANCE Button
26. MIC 2 Input
27. REMOTE SENOR
28. SPEAKER - TWEER
29. SPEAKER - Full RANGE
30. AUDIO OUT RCA Jack
31. VIDEO OUT RCA Jack
32. MAIN POWER Switch
33. DC IN Jack
34. USB Port For Charging
REMOTE LOCATION CONTROLS
Notes:
1. Press the MUTE button of remote to mute the audio sound, press again to
resume. Other button of remote same as main unit function.
2. Remove spacer tab before using this unit for first time .
3. Press the buttons of the remote to pointing the main unit remote senor
area to fully control the main unit.
TO INSTALLING / REPLCING REMOTE BATTERY
1. Pull the battery door at the back of the unit as shown figure.
2. Insert the battery in the battery door with “+" positive facing
up. Only CR2025 3V lithium battery should be used.
3. Insert the battery door with new battery back into the unit.
BATTERY WARNING:
1. Make sure the correct polarity of battery to be installed.
2. Make sure you dispose of batteries properly (refer to your
local regulations).
3. Do not open batteries.
4. Do not dispose of batteries in fire.
5. Do not heat up batteries.
6. Do not expose batteries to water.
7. Do not charge or recharge batteries.
Loading...