Mocka Vigo Bedside Table Assembly Instructions Manual
Phillips & Flathead screwdrivers required
*We recommend using a Flathead screwdriver to tighten
all locking nuts 100% before rst use.
A B
C
D
E
Hardware Supplied
25mm
screw x4
12mm
screw x8
50mm
screw x16
slide rail
x2
bolt &
nut set x18
E1
E2
E3
E4
F
dowel
x8
G
H I
wall
anchor x2
safety
strap x2
25mm
screw x2
WARNING: Any furniture that is not anchored to a wall has the potential to tip
over in certain circumstances, i.e. if a child attempts to climb up on the furniture
or in the event of an earthquake. Accordingly, we recommend that all furniture
is anchored to a wall. We supply a free safety wall anchor with all furniture sold
and we recommend these are used to prevent your product tipping. The fixing
device provided should fit most wall types, but please note that different wall
materials may require different fixing devices from those supplied.
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
Vigo Bedside Table
1
mocka.co.nz | mocka.com.au
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.
1
2
Attach 1x slide rail (E1) to panel [3] using 2x 12mm screws (C). Attach
1x slide rail (E3) to panel [4] using 2x 12mm screws (C). Tighten with a
screwdriver.
Attach panels [3], [4] and [5] together using 4x bolts (A) and secure using
4x locking nuts (A). Tighten with a flathead screwdriver.
5
4
3
E1
E3
C
C
C
C
4
3
A
A
A
A
A
C
Vigo Bedside Table
2
mocka.co.nz | mocka.com.au
Assembly Instructions
Loading...