Mocka Soho Wooden Highchair Assembly Manual
IMPORTANT!
KEEP FOR FUTURE REFERENCE:
Backboard Upper
metal rod
Highchair Leg
Footboard
Seat board
Safety Rail
Safety strap
Support brace
Only use the highchair on a flat, even and horizontal floor.
Do not elevate the highchair on any structure or table.
WARNING: Never leave your child unattended in the highchair. Strict
adult supervision is required at all times.
WARNING: Ensure the safety strap is in use at all times to avoid the
child slipping downwards and causing injury. We recommend the use of
the shoulder and waist harness at all times to avoid injury caused by
falls.
WARNING: Do not use the highchair unless components are correctly
fitted and adjusted.
WARNING: Ensure the highchair is positioned away from objects or
structures that can cause injury. Be aware of the risk of open fire and
other sources of strong heat, such as electric bar fires, gas fires etc, in
the vicinity of the highchair.
WARNING: Ensure both the seat and footrest are clicked into position
and cannot be moved by hand, before placing the child in the highchair.
WARNING: For babies/toddlers under 2 years old, please ensure the
seat is positioned on the 1st or 2nd level from the top ONLY.
Do not tighten all screws until all components have been assembled.
The highchair should not be used until the child can sit up unaided.
Do not use the highchair if any part is broken, torn or missing.
Soho Wooden Highchair
1
mocka.co.nz | mocka.com.au
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.
screwdriver required
The best way to clean your highchair – especially the tray is
with a clean damp cloth, and then wipe completely dry.
We recommend you DON’T use household cleaners as these
Using a damp cloth and wiping dry will ensure longevity of
your highchair.
To alter the seat and footrest heights after assembly, simply
loosen all the screws in the upper and lower backrests and
the metal rods on both sides of the highchair. Once loosened
this will allow the seat and footrest to be pulled out. Insert into
the new positions and then lock in place by re-tightening all
the screws. Ensure both the seat and footrest are locked into
position and cannot be moved by hand, before placing the
child in the highchair
Thank you!
The Mocka Team
x6
B
A
x4
C
E
D
F
x6
x1
x4
x1
screw
long screw
bolt nut
Allen key
footpad
safety strap
G
H
leg
extender
small screw
x2
15 mm
x2
Hardware Supplied
Pre-installed Hardware
could lift the varnish and upset the wood finish.
Soho Wooden Highchair
2
mocka.co.nz | mocka.com.au
Assembly Instructions
x2
C
A
A
A
A
B
B
C
C
x2
B
Ensure all components slot into the corresponding
grooves on the inside of the legs. Loosely fasten rods
(E) provided. Attach wooden support brace using long
screws (B) and bolt nuts (C) as shown.
1
To begin assembly, line up backboards, iron rods, and
support brace between both legs of the highchair.
to the highchair legs using screws (A) and allen key
Soho Wooden Highchair
3
mocka.co.nz | mocka.com.au
Assembly Instructions
Loading...