Mocka Oli Bookcase Assembly Instructions Manual
Oli Bookcase
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.
A
44x
bolt
E
18x
screw
I
1x
adjuster
B
44x
locking nut
F
6x
hinge
J
20x
cover
C
36x
dowel
G
3x
stopper
K
12x
screw
D
3x
latch
H
6x
screw
L
12x
wedge
W
3x
wall strap
Y
3x
screw
3x
wall screw
X
3x
anchor
Z
3x
washer
WARNING: Any furniture that is not anchored to a wall has the potential to tip
over in certain circumstances, i.e. if a child attempts to climb up on the furniture
or in the event of an earthquake. Accordingly, we recommend that all furniture
is anchored to a wall. We supply a free safety wall anchor with all furniture sold
and we recommend these are used to prevent your product tipping. The fixing
device provided should fit most wall types, but please note that different wall
materials may require different fixing devices from those supplied.
Hardware Supplied Wall Strap
Phillips & Flathead screwdrivers required
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
*We recommend using a Flathead screwdriver to tighten all locking nuts 100% before first use.
Please clear any loose wood from the locking nut holes before inserting the nut to ensure it locks 100%.
1
Oli Bookcase
Assembly Instructions
1
gap
14
12
12
2
12
12
14
2
I
I
2
2
Firmly screw 4x leg [12] and 1x leg [14] to the base of panel [2].
Screw adjuster (I) into leg [14] and level to floor if needed.
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
Attach 8x bolt (A) to panel [2].
Tighten with a screwdriver.
2
Oli Bookcase
Assembly Instructions
3
4
5
7
6
5
2
10
5
10
6
10
5
7
Insert 8x dowel (C) into panel [2].
Attach panels [5], [6] and [7] to panel [2] with 8x locking nut (B).
Tighten with a screwdriver.
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
Attach 3x stopper (G) to panels [6] and [7] with 6x screw (H).
Tighten with a screwdriver.
Slide 3x panel [10] into the groves in panels [5], [6] and [7] to form the
back of the unit as shown.
3
Loading...