Mocka Jolt Six Drawer - Wide Assembly Instructions Manual
Jolt Six Drawer - Wide
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.
A B
dowel
x31
H
L + R slide
rail x6
WARNING: Any furniture that is not anchored to a wall has the potential to tip over in certain
circumstances, i.e. if a child attempts to climb up on the furniture or in the event of an earthquake.
Accordingly, we recommend that all furniture is anchored to a wall. We supply a free safety wall anchor
with all furniture sold and we recommend these are used to prevent your product tipping. The fixing device
provided should fit most wall types, but please note that different wall materials may require different fixing
devices from those supplied.
screw
x36
I
J K L M N
small bolt
x30
C D E F G
locking
bolt
x13
small
locking nut
Hardware Supplied
nut x13
x30
screw x4
long
small
screw x60
plastic
glide x6
L + R slide
long
dowel x6
rail x6
O
nail
x28
wall
strap x1
WV
screw
x1
X
wall wall
anchor
x1
Wall Strap
r/washer
screw
x1
ZY
washer
x2
Phillips & Flathead screwdrivers
and hammer required
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
1
Jolt Six Drawer - Wide
Assembly Instructions
1
E
E
A
2
A
E
E
E
F
E
E
E
E
G
E
F
E
E
G
E
E
E
E
F
2
E
E
E
E
G
A
A
C
2
A
C
C
A
A
C
A
A
C
A
3
A
C
A
3
To begin assembly attach 3x slide rails (F) & (G) in place
on each of the
each rail bracket. Fasten
in
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
panels [2] and [3] using 3x small screws (E)
all screws with a screwdriver.
Screw 6x bolts (C) and insert 18x dowels (A) into
corresponding holes
in panels [2] and [3].
2
Jolt Six Drawer - Wide
Assembly Instructions
3 4
E
E
E
G
E
E
G
E
E
E
E
C
A
E
4
E
E
E
4
Attach 3x slide rails (F) and (G) into each side of panel
[4] using 18x small screws (E). Fasten all screws with a
screwdriver.
F
E
E
F
E
G
E
E
E
F
5
5
3
E
Slot 3x panels [5] into the dowels in panel [3]. Place a bolt (C) and
dowel (A) into panel [6] and attach connecting parts with a locking
nut (D). Tighten with a screwdriver.
D
C
5
A
6
D
3
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
Loading...