US
MxDisplay: Regulatory Notice
Security-Vision-Systems
MxDisplay with RFID and WiFi
MX-Display1-EXT
for MOBOTIX Door Stations
and Video Systems
MOBOTIX MxDisplay
MX-Display1-EXT
(available in black or white)
Federal Communications Commission (FCC) and Industry Canada (IC)
Notice for MX-Display1-EXT (M/N: MX-Display)
32.107_US_V1_09/2014
(FCC ID: YYRDISPA, IC ID: 9357A-DISPA)
NOTICE:
This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference that may cause undesired operation.
NOTICE:
Le présent appareil est conforme aux CNR d‘Industrie Canada applicables aux appareils radio exempts de
licence. L‘exploitation est autorisée aux deux conditions suivantes:
(1)
l‘appareil ne doit pas produire de brouillage, et
(2)
l‘appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d‘en
compromettre le fonctionnement.
NOTICE:
Changes or modifications made to this equipment not expressly approved by MOBOTIX AG may void the FCC
authorization to operate this equipment.
NOTICE:
This Class B digital apparatus complies with Canadian ICES-003.
NOTICE:
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
NOTE:
This equipment has been tested and found to comply with the limits for a ClassB digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Ministry of Internal Aairs and Communications Notice for
MX-Display1-EXT
NOTICE:
• This device has been granted a designation number by Ministry of Internal Aairs and Communications.
• This device should not be modified (otherwise the granted designation number will be invalid).
Innovations - Made in Germany
The German company MOBOTIX AG is known as the leading pioneer in network camera technology and its
decentralized concept has made high-resolution video systems cost-ecient.
MOBOTIX CORP • Manhattan (NY) • Phone: 888-MOBOTIX (662 6849) • us-sales@mobotix.com • Made in Germany
www.mobotix.com
US
MxDisplay: Conformity
Declaration of Conformity
Security-Vision-Systems
Hersteller:
Manufacturer:
Fabricant:
Produkt:
Product:
Produit:
Typ:
Type:
Type:
MOBOTIX AG
Netzwerk-Display
Network display
Achage de réseau
MX-Display1-EXT
Bei bestimmungsgemäßer Verwendung erfüllt das bezeichnete Produkt die Bestimmungen gemäß
Artikel 3 der R&TTE-Richtlinie 1999/5/EG.
The product identified above complies with the essential requirements of article 3 of the guideline R&TTE 1999/5/EG.
Le produit désigné ci-dessus est conforme aux exigences fondamentales de l’article 3 de la directive R&TTE 1999/5/EG.
Angewendete harmonisierte Normen:
Harmonised standards applied:
Normes harmonisées:
Safety EN 60950-1:2006/A11:2009/
A1:2010/A12:2011
EMC EN 301 489-1 (V1.9.2)
EN 301 489-3 (V1.4.1)
ERM-SRD EN 300 330-1 (V1.7.1)
EN 300 330-2 (V1.5.1)
Weitere angewendete Normen:
Other harmonised standards applied:
Autres normes harmonisées:
CFR47, FCC Part15B, Part15C
RSS 210 Issue 8
Japan IFERW
Adresse:
Address:
Adresse:
MOBOTIX AG
Kaiserstrasse
67722 Langmeil
Germany
2014 • Declaration of Conformity: www.mobotix.com> Support> Media Library> Certificates
+ TK-Nr. /
Fon:
Fax:
E-Mail:
Langmeil, September 22, 2014
Ort, Datum
Place & date of issue
Lieu et date
Phone number / N° de communication:
+49 6302 981 6-103
+49 6302 981 6-190
us-sales@mobotix.com
Dr. Oliver Gabel
CTO, MOBOTIX AG
Name und Unterschrift
Name and signature
Nom et signature
Notes
• This product must not be used in locations exposed to the dangers of explosion.
• Please follow the notes on installing and operating the device in the
and the
MxDisplay Quick Guide
documents (www.mobotix.com in the Support> Manuals section).
• The MxDisplay is only to be used together with the MOBOTIX original frames and the in-wall and on-wall
housings.
• Electrical installation: Electrical systems and equipment may only be installed, modified and maintained
by a qualified electrician or under the direction and supervision of a qualified electrician in accordance
with the applicable electrical guidelines. Make sure to properly set up all electrical connections.
• Network security: MOBOTIX products include all of the necessary configuration options for operation in
Ethernet networks in compliance with data protection laws. The operator is responsible for the data protection
concept across the entire system. The basic settings required to prevent misuse can be configured in the
software and are password-protected. This prevents unauthorized parties from accessing these settings.
•
Make sure the device is not operated outside of its operating temperature range of 0 to +40 °C/+32 to +104 °F.
MOBOTIX MxDisplay Quick Install
Dimensions Back
99 mm/3.9in
99 mm/3.9in
Innovations - Made in Germany
The German company MOBOTIX AG is known as the leading pioneer in network camera technology and its
decentralized concept has made high-resolution video systems cost-ecient.
MOBOTIX CORP • Manhattan (NY) • Phone: 888-MOBOTIX (662 6849) • us-sales@mobotix.com • Made in Germany
www.mobotix.com
Copyright © MOBOTIX AG 2014 • Made in Germany • Technical information subject to change without notice.