User
User
Manual
Manual
Model
Model
Hereby,
Hereby,
declares
declares
requirements
requirements
provisionsofof
provisions
that
that
compliance
compliance
Mobile
Mobile
VFD
： VFD
MOBILE
MOBILE
this
this
with
with
and
and
Directive
Directive
Phone
Phone
320
320
LIMITED
LIMITED
Mobile
Mobile
the
the
other
other
2014/53/EU.
2014/53/EU.
1
Phoneisisinin
Phone
essential
essential
relevant
relevant
2
Know your phone
3
SIM/SD card installation
1.1.Power
Power
off
off
mobile.
mobile.
2.2.Refer
Refertoto
the
the
following
following
picture
picture
for
for
SIM
SIM//SDSD
card
card
installation.
installation.
4
Charging the phone
You
You
can
can
charge
charge
your
your
device
device
using
usingaa
charger
chargerororbyby
connecting
connecting
itittotothe
the
computer
computer
using
usingaa
USB
USB
cable
cable
(comes
(comes
with
with
the
the
phone).
phone).
1.1.Please
Please
remind
remind
the
the
front
front
and
and
back
backofof
the
the
plug.
plug.
2.2.Use
Use
only
only
original
original
charger
charger
and
and
cables.
cables.
Other
Other
chargers
chargersoror
cables
cables
may
may
damage
damage
the
the
device
deviceoror
your
your
device.
device.
This
This
will
will
invalidate
invalidate
your
your
phone
phone
warranty.
warranty.
Operating Frequency Band (RF)：
GSM850:824-849 MHz(TX), 869-894 MHz(RX),
EGSM900:880.0–915.0MHz(TX), 925.0–960.0MHz(RX)
DCS 1800: 1710.0–1785.0MHz (TX), 1805.0–1880.0 MHz (RX)
PCS 1900: 1850.0–1910.0MHz (TX), 1930.0–1990.0MHz (RX)
WCDMA BAND1: 1920-1980MHz (TX), 2110-2170MHz (RX)
WCDMA BAND8: 880-915MHz (TX), 925-960MHz (RX)
Bluetooth: 2402-2480MHz (TX/RX)
WIFI: 2412-2462MHz (TX/RX)
GPS:1575.42MHz
FM：87.5MHz-108MHz(RX)
Modulation mode：
GMSK (GSM850/GSM900/DCS/PCS)
WCDMA Uplink： BPSK/QPSK/16QAM；
WCDMA Downlink：BPSK/QPSK /16QAM/64QAM
GFSK/π/4-DQPSK/ 8-DPSK (Bluetooth)
BPSK/QPSK/16QAM/64QAM/DSSS/OFDM/ CCK (WIFI b/g/n)
BPSK/QPSK (GPS)
5
6
Max Output Power：
Item
Max Output Power(dBm)
GSM850/GSM900
33.5
PCS1800/DCS1900
30.5
WCDMA900/WCDMA2100
23BT5.5
802.11b
15.5
802.11g
13.5
802.11n 20M
12.5
802.11n 40M
11
7
CAUTION：
1. U se careful with the earphone maybe excessi ve sound pressure from
earphones and headphones can cause hearing loss.
2. Risk of explosion if battery is repl aced by an incorrect type, dispose of
used batteries according to the instructions.
3. The product shall only be connected to a USB interface of version
USB2.0.
4. Adapter shall be installed near the equipment and shall be easily
accessible.
5. EUT Temperature: -20℃～+60℃.
6. Charger1:A31A-050100U-EU1
Charger2:A31A-050100U-EU1
Charger3:WUK550mA5V00
Charger4:TUUK050055
Charger5:TUAU050055
7. The device complies with RF specifications when the device used at
5mm from your body.
8. To prevent possible hearing damage, do not listen at high volume
levels for long periods.
9. Earphone and USB cable are shielded.
Hereby, vodafone, declares that this device (VFD 321/ VFD 320)is in
compliance with the essential requirements and other relevant provisions
of Directive 2014 / 53 / EU. The full text of the EU declaration of conformity
is available at the following internet address: www.vodafone.com
8
FCCRegulations
（1 5C）Th is device complies with part 15 of t he FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
Changes or modifications not expressly approved by the
manufacturer could void the user ’s authority to
operate the equipment.
The antenna(s) u sed for this transmitter must not be
co-located or operating in conjunction with a ny
other antenna or transmitter.
(15B)This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant t o part 15 of the FCC Rules.
These limits a re designed to provide re asonable
protection against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to rad io communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined b y turning
9
the equipment off a nd on, the u ser is
encouraged to try to co rrect the interference by
one or more of the following measures:
Reorient or relocate th e receiving antenna.
Increase the separation betweenthe equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV t echnician for
help.
RadioFrequency (RF)Energy
This phone is designed and manufactured not to exceed
the emission limits for ex posure to radio
frequency (RF) energy set by the Federal
Communications Commission of the United
States.
During SAR testing, this device was set to transmit at its
highest certified p ower level in all tested
frequency bands, and placed in positio ns that
simulate RF exposure in usage against the
head with no separation, and near the body
with the separation of 10 mm. Although the
SAR is determined at the highest certified
power level, the ac tual SAR level of the device
while operating can be well below the
maximum value. This is because the phone is
designed to operate at multiple power levels so
as t o use o nly the p ower required to reach the
network. In general, the closer you are to a
wireless base station antenna, the lower the
power output.
The exposure standard for wireless d evices employing
a unit of measurement is known as the Specific
Absorption Rate, or SAR. The SAR limit set b y
the FCC is 1.6 W /kg.
This device is complied with SA R for general population
/uncontrolled exposure limits in ANSI/IEEE
C95.1-1992 and had been tested in
accordance with the measurement methods
and procedures sp ecified in IEEE1528.
The FCC has gra nted an Equipment Authorization for
this model phone with all reported SAR levels
evaluated as in compliance with th e FCC RF
exposure guidelines. SAR information on this
model phone is on file with the FCC and can
be found under the Display G rant section of
www.fcc.gov/oet/ea/fccid after searching on
FCC ID: Q PN-VFD320
For this device, the highest reported SAR value for
usage against the head is1.133W/kg, and for
usage near th e body is 1.133W/kg.
While there may be differences b etween the SAR levels
of various phones and at various positions,
they all me et the government requirements.
SAR compliance for body-worn operation is based on a
10
11
separation distance of 10 mm between t he unit
and the human b ody. Carry this device at least
10 mm away from your body to ensure RF
exposure level co mpliant or lower to the
reported level. To support body-worn operation,
choose the b elt clips or holsters, which d o not
contain metallic components, to maintain a
separation of 10 mm between this device and
your body.
RF exposure compliance with any b ody-worn accessory,
which contains metal, was not tested and
certified, and using such body-worn accessory
should be avoided.
Loading...