MobiWireS NIKITI Users manual

Moblie Appearance picture

Manufacturer：Mobiwire

Manufacturer trademark: Model：Mobiwire NIKITI, Altice F2

Battery Type

Battery Capacity

Talk time

Standby time

Li-battery

1000mAh

About 8hr

About 300hr

Technical Specifications

Weight: 78.7g (with battery) Size: 111.61*49.31*14.8mm Battery: 3.7Li-ion For the network: GSM850MHz/PCS1900MHz Battery refer to the following table:

Operating Frequency Band (RF): GSM850:824.0-849.0MHz(TX),869.0-894.0MHz(RX) PCS1900:1850.0-1910.0MHz(TX),1930.0-1990.0MHz(RX) Bluetooth:2402-2480MHz(TX/RX) FM:87.5MHz-108MHz

Modulation mode: GMSK GFSK/π/4-DQPSK/8-DPSK

Max. Of Transmit power: GSM850:PCL=5,PWR=32.5±0.5dBm PCS1900:PCL=0,PWR=29.5±0.5dBm Bluetooth:4dBm+/-1dBm The crystal the tranceiver use is 26MHz

Operating temperature:-20~60℃ Charging temperature:Charging 0~55℃;Discharging:-20~60℃ Battery technical:Li-ion Low Voltage:3.6V Nominal Voltage:3.7V

High Voltage:4.2V Charge Restriction Voltage:4.2±0.03V Rated Capacity:1000mAh Battery low voltage:3.5V Operating Relativity Humidity Range:≦93%

charger model：A31-25132-5v550 manufacturer：Aohai

Notice: The actual condition for mobile phones using has the relation to the network of the local environmental conditions, SIM card and the way using. Warning: For the consequences result by violating the following recommendations or using mobile phones In accurately, the manufacturers has no responsibility. Explain: If relate to the upgrades, without notice. The Company has the right for the final interpretation of this statement.

Table of Contents

Moblie Appearance picture ................................. 1

1. Quick start ............................. 9

Icon Explain .......................................................... 9

Install SIM card .................................................. 10

Install T-flash card .............................................. 10

Installing Battery ................................................ 10

Battery Charging ................................................. 10

Switching on ........................................................11

2. Call function ........................ 12

Dialing telephone ................................................ 12

Receiving telephone ............................................ 12

Call in the menu .................................................. 13

3. Menu functions .................... 14

Messaging ........................................................... 14

Call center ........................................................... 18

Phonebook .......................................................... 19

Camera ................................................................ 16

Multimedia ......................................................... 20

FM radio ............................................................. 22

Profiles ................................................................ 20

Extras ...................................... 错误!未定义书签。

Bluetooth ............................................................ 25

File manager ....................................................... 26

Settings ............................................................... 26

4. Input methods ..................... 31

5. Phone maintenance ............. 33

6. Accessories ......................... 355

7. SAR .................................. 356

Foreword

1882 ODO mobile phones user, thank you for choosing our mobile phone! Our cellular phones is according with the communication industry standards of PRC, and also according with the standards of European, and are approved for GSM networks. Your phone may be used internationally with various networks depending on your roaming arrangements with your service provider. To use this phone you must subscribe to a GSM service from a provider. We have included many features in this device but their function depends on the features available with your subscribed wireless network. Please contact your service provider for more information. We strongly recommend you carefully read and understand this manual before using your phone in order to keep it under best conditions for your effective usage and utmost satisfaction.

Safety

Never attempt to disassemble your phone. You alone are responsible for how you use your phone and any consequences of its use. As a general rule, always switch off your phone wherever the use of a phone is prohibited. Use of your phone is subject to safety measures designed to protect users and their environment. Do not use your phone in damp areas (bathroom, swimming pool…). Protect it from liquids and other moisture.

Do not expose your phone to extreme temperatures lower than

-20°C and higher than +60°C. The physicochemical processes created by chargers impose temperature limits when charging the battery. Your phone automatically protects the batteries in extreme temperatures. Do not leave your phone within the reach of small children (certain removable parts may be accidentally ingested). Electrical safety

Only use the chargers listed in the manufacturer’s catalogue.

Using any other charger may be dangerous; it would also invalidate your warranty. Line voltage must be exactly the one indicated on the charger’s serial plate. Aircraft safety When traveling by plane, you will need to switch your phone off when so instructed by the cabin crew or the warning signs. Using a mobile phone may be dangerous to the operation of the aircraft and may disrupt the phone network. Its use is illegal and you could be prosecuted or banned from using cellular networks in the future if you do not abide by these regulations. Explosive materials Please comply with warning signs at petrol station when personnel asking you to switch your phone off. You will need to comply with radio equipment usage restrictions in places such as chemical plants, fuel depots and at any location where blasting operations are under way. Electronic equipment To avoid the risk of demagnetization, do not let electronic devices close to your phone for a long time. Electronic medical equipment Your phone is a radio transmitter which may interfere with electronic medical equipment or implants, such as hearing aids, pacemakers, insulin pumps, etc. It is recommended that a minimum separation of 15 cm be maintained between the

phone and an implant. Your doctor or the manufacturers of such equipment will be able to give you any advice you may need in this area. Hospitals Always make sure that your phone is switched off in hospitals when so instructed by warning signs or by medical staff. Road safety Do not use your phone when driving. In order to give your full attention to driving, stop and park safely before making a call. You must comply with any current legislation. Distance of operation This phone model has been tested and meets radiofrequency exposure guidelines when used As follows:

·Against the ear: place or receive a phone call and hold the phone as you would a wire line telephone.

·Body worn: when transmitting, place the phone in a carry accessory that contains no metal and positions the phone a minimum of 2.5cm form your body. Use of other accessories may not ensure compliance with radiofrequency exposure guidelines. If you do not use a body worn accessory and are not holding the phone at the ear, position the phone a minimum of

2.5 cm from your body,

·Data operation: when using a data feature, position the phone a minimum of 2.5cm from your body for the whole duration of the data transmission

1. Quick start

Icon

Function description

Network signal strength:

number of the more stronger the signal;

Battery capacity

number of the more power the more full;

Messaging

SIM have unread messages

Missed call

SIM have missed calls

Used profiles

Different icons show different icon: General, Silent, Meeting, Outdoor

Headset

Plug in headset

Alarm

Alarm function opened

Key lock

Show key and screen lock

Icon Explain

Install SIM card

This phone supports two SIM cards. Find SIM card’s

groove in the back of the phone and slide it completely there. During installation, please make sure the chip is facing downwards and pay attention to slot direction.

Note：

1. Keep SIM card out of children’s touch.

2. Any abrasion or folding could easily damage SIM card, so please be extremely careful when you insert, Remove and preserve it.

3. Please make sure that you have cut off the power supply and have taken out battery before you remove SIM card.

Install T-flash card

1. First switch off the phone and remove the battery.

2. Push the metal card holder toward the bottom of the phone and lift the released end of the holder.

3. Place the memory card into the holder with the metal contacts face down and push the holder until it locks into place.

Note:

1.To avoid damaging memory card, please do not plug memory card fast or frequently.

2. Please regularly backup information in the cards on other equipment when you use Cards like T-flash! Improper use or other uncertain factors may cause the damage or loss to the content in the cards.

Installing Battery

Align the battery chip with the metallic salient point in battery jar, insert the battery until it is inserted into the battery jar. Slide battery cover into back of the phone until it is locked.

Battery Charging

Plug one end of the charger into the bottom of the phone, i.e., the charging plug into attachment mode and the other end into electrical outlet, Screen will display the charging sign. After

charging is finished, just pull out the plug.

Switching on

Long press the Red key to switch your phone on

1. If there is no SIM card, SIM card is defective, or SIM card contact is loose, you will be prompt with a warning after powering on, shut down and check your SIM and its installation.

2. If inserted SIM card only into the phone, meanwhile phone code and PIN code is turn on. When switched on, after entering the PIN code and phone code, the phone enter the standby mode by the current SIM.

3. If the phone detected authorized network, the screen will display network name and signal strength；If there is no authorized network is found ， the phone can only make emergency calls or use non-communications features.

2. Call function

Dialing telephone

1. Direct dial In standby mode, press the corresponding numeric keys to enter the phone number that you want to dial, including necessary area codes. Short Press the Right soft key [Clear] to delete one character, and Long Press delete all inputs, press the Green key to dial.

2.Dialing from Phonebook Enter the Phonebook via the menu, use the Up/Down Navigator keys to scroll to the desired contact, or press the first letter of the name of the desired contact as saved in your phonebook for quick access to names beginning with the letter then scroll to the desired, press the green key to dial.

3. Dialing from Call history Enter the Call center (press the Green key from standby or via the menu), use the Up/ Down navigator keys to scroll to the desired contact, press the green key to dial.

4. Dial emergency service You can directly dial the emergency service number without SIM card. Different networks use different urgency service numbers, so for details please inquire the network operation company.

Receiving telephone

When there is an incoming call, the phone will give corresponding alert, if your network supports caller ID, the

screen will display caller’s name or number (depending on

whether there is information of the caller in your phonebook).

1. Press the green key or press the Left soft key and confirm [Answer] to answer the incoming call.

2. If function of [call center/call settings/Advanced setting/ Answer mode] is selected as [Any-key], press the any key to answer the incoming call except the Right soft key or the Red

+ 26 hidden pages