MOBILUS COSMO G3+ User Manual

User manual of
COSMO | G3+ controller.

www.mobilus.pl

1. GENERAL INFORMATION

COSMO | G3

+

is a 4-channel remote control, designed for remote control receivers brand
MOBILUS (radio remote controls for roller shutters, awnings, blinds / control modules for
motors without radio communication module / ON / OFF modules).

• Support of 4 channels.

• Support 4 channel groups.

• Bi-directional communication - the opportunity to receive additional feedback information

from receivers.

Please refer to the instruction manual that tells how to safely use the device. You are solely
responsible for any damages resulting from the using the device in a manner inconsistent with
its intended purpose. The manufacturer accepts no responsibility for damage or injury caused
by misuse, improper handling and running.

2. CONTENTS OF THE PACKAGE

The packaging contains the following items:

• remote COSMO | G3

+

,

• 1 CR2450 3 V battery in remote,

• user manual.

3. TECHNICAL PARAMETERS

• 4 channels remote

• Dynamic code

• FSK modulation

• 868 MHz

• Bi-directional communication

• 1 CR2450 3 V

• Dimensions: 75 x 45 x 14 mm / waga: 30 g

2

4. POWER SUPPLY

The device is powered by single battery CR2450. In order to change the battery, open housing
of the remote.

1. Between the lower and the upper part of the housing slide flat, rigid tool in the position

shown in

Fig. 4a.

2. Then, slowly and firmly spread apart the two housing parts - Fig. 4b.

3. In the lower part of the housing is a battery holder CR2450 3 V - Fig. 4c.

Replace the old battery with a new one, pay attention to the polarity.

4. Close the remote control.

Fig. 4a Fig. 4b

Fig. 4c

3

5. DESCRIPTION OF THE REMOTE CONTROL

1

2

34

6

8

75

1. Pendant.

2. LED’s indicating the selected channel.

3. LED’s indicating radio transmission (blue, red).

4. Control button UP ( TURN ON for modules ON/OFF ).

5. Navigation channels button LEFT.

6. STOP button ( TURN ON/TURN OFF for modules ON/OFF; UP/STOP/DOWN in case of the
modules operating in steps mode ).

7. Navigation channels button RIGHT.

8. Control button DOWN ( TURN OFF for modules ON/OFF ).

4