Power On ........................................................................................................................... 3-5
1-21-3
User's Manual
Copyright Notice
We take every care in the preparation of this document, but no guarantee is given as to the
correctness of its contents. Our products are under continual improvement and we reserve
the right to make changes without notice.
Trademarks
All trademarks are the properties of their respective owners.
Revision History
▶ Version: 1.2
▶ Date: 10, 2017
FCC-B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and radiates radio frequency energy, and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
▶ Reorient or relocate the receiving antenna.
▶ Increase the separation between the equipment and receiver.
▶ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
▶ Consult the dealer or an experienced radio TV technician for help.
NOTE
▶ The changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
▶ Shield interface cables and AC power cord, if any, must be used in order to comply
with the emission limits.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
▶ This device may not cause harmful interference.
▶ This device must accept any interference received, including interference that may
cause undesired operation.
1-41-5
User's Manual
FCC RF Radiation Exposure and SAR Statements
FCC RF Radiation Exposure and SAR Statements SAR Statement. The tablet has
been tested for body-worn Specific Absorption Rate (SAR) compliance. The FCC has
established detailed SAR requirements and has established that these requirements. RF
Exposure Information The radio module has been evaluated under FCC Bulletin OET 65C
(01-01) and found to be compliant to the requirements as set forth in CFR 47 Sections,
2.1093, and 15.247 (b) (4) addressing RF Exposure from radio frequency devices. This
model meets the applicable government requirements for exposure to radio frequency
waves. The highest reported SAR level for usage near the body (0mm) is 1.28 W/kg, and
for the simultaneous transmission is 1.59W/kg.
▶ WiFi 5G indoor use only
▶ Operations in the 5.15-5.25GHz band are restricted to indoor usage only
CE Conformity
This device is in compliance with the essential safety requirements
and other relevant provisions set out in the European Directive.
Battery Regulations
European Union:
not be disposed of as unsorted household waste. Please use the
public collection system to return, recycle, or treat them in compliance
with the local regulations.
Taiwan:
廢電池請回收
California, USA: The button cell battery may contain perchlorate material and requires
special handling when recycled or disposed of in California.
For further information please visit: http://www.dtsc.ca.gov/hazardouswaste/
perchlorate/
Safety Guideline for Using Lithium Battery
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the equipment manufacturer. Discard used batteries
according to manufacturer’s instructions.
be collected separately for recycling or special disposal.
Batteries, battery packs, and accumulators should
For better environmental protection, waste batteries should
WEEE Statement
European Union:
Waste Electrical and Electronic Equipment, Directive 2002/96/EC,
which takes effect on August 13, 2005, products of "electrical and
electronic equipment" cannot be discarded as municipal waste
anymore and manufacturers of covered electronic equipment will be
obligated to take back such products at the end of their useful life.
Under the European Union ("EU") Directive on
1-61-7
Safety Instructions
Read the safety instructions carefully and thoroughly. All cautions and
warnings on the equipment or user’s manual should be noted.
Keep this equipment away from humidity and high temperature.
Lay this equipment on a stable surface before setting it up.
The openings on the enclosure are used for air convection and to
prevent the equipment from overheating. Do not cover the openings.
• Do not leave the equipment in an unconditioned environment with
a storage temperature above 60ºC (140ºF) or below -20ºC (-4ºF),
which may damage the equipment.
• This unit should be operation under maximum ambient temperature
of 50ºC (120ºF) or under 60ºC (140ºF) for light loading applications.
Followings are requirements of battery storage:
1. If the storage duration is within 3 months, please remain the
temperatureat-20℃ ~45℃ ; If the storage duration is above
3 months but within 1 year, please remain the temperature at
5. For the maximum battery discharging performance, please
remainthestoragetemperatureat25℃ .
User's Manual
• Make sure the power voltage is within safety range and has been
adjustedproperly to thevalueof 100~240V beforeconnectingthe
equipment to the power outlet.
• Always unplug the AC power cord before installing any add-on card
or module to the equipment.
• Always disconnect the AC power cord or uninstall the battery pack
or switch off the wall socket if the equipment would be left unused
for a certain time to achieve zero energy consumption.
Place the power cord in a way that people are unlikely to step on it. Do
not place anything on top of the power cord.
Always keep the strong magnetic or electrical objects away from the
tablet.
Never pour liquid into the opening that could damage the equipment
or cause an electrical shock.
If any of the following situations arises, get the equipment checked by
a service personnel:
• The power cord or plug is damaged.
• Liquid has penetrated into the equipment.
• The equipment has been exposed to moisture.
• The equipment has not worked well or you can not get it work
according to User’s Manual.
• The equipment was dropped and damaged.
• The equipment has obvious signs of breakage.
Green Product Features
• Reduced energy consumption during use and stand-by
• Limited use of substances harmful to the environment and health
• Easily dismantled and recycled
• Reduced use of natural resources by encouraging recycling
• Extended product lifetime through easy upgrades
• Reduced solid waste production through take-back policy
Environmental Policy
• The product has been designed to enable proper reuse of parts
and recycling and should not be thrown away at its end of life.
• Users should contact the local authorized point of collection for
recycling and disposing of their end-of-life products.
1-81-8
Part No.G52-17A12X8
Introductions
User's Manual
TABLET PC
Loading...
+ 19 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.