MobileDemand LC T8650 User Manual
1
Preface
User’s Manual
Tablet PC
Preface
1-2
Contents
Chapter 1: Preface
Content .......................................................................... 1-2
Regulations and Statements ........................................ 1-3
FCC-B Radio Frequency Interference Statement ....... 1-3
FCC Conditions ......................................................... 1-3
FCC ........................................................................... 1-4
CE Conformity ........................................................... 1-4
Battery Regulations.................................................... 1-4
WEEE Statement ....................................................... 1-5
Safety Instructions........................................................ 1-5
Trademarks ................................................................... 1-7
Reversion History ......................................................... 1-7
Chapter 2: Introductions
Manual Map ................................................................... 2-2
Unpacking ..................................................................... 2-2
Product Overview ......................................................... 2-3
Specification ................................................................. 2-6
Chapter 3: Getting Started
Power Management ...................................................... 3-2
AC Power .................................................................. 3-2
Connecting the AC Power .......................................... 3-2
Battery Power ............................................................ 3-3
Powering ON ............................................................. 3-4
Power Management in Windows OS .......................... 3-5
Basic Operations .......................................................... 3-8
Knowing the Display Features .................................... 3-8
Wireless Activation ................................................... 3-10
1-3
Regulations and Statements
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause
undesired operation.
changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Preface
1-4
FCC RF Radiation Exposure and SAR Statements SAR Statement. The T8650 has been tested
for body-worn Specific Absorption Rate (SAR) compliance. The FCC has established detailed
SAR requirements and has established that these requirements. RF Exposure Information
The radio module has been evaluated under FCC Bulletin OET 65C (01-01) and found to be
compliant to the requirements as set forth in CFR 47 Sections, 2.1093, and 15.247 (b) (4)
addressing RF Exposure from radio frequency devices. This model meets the applicable
government requirements for exposure to radio frequency waves. The highest SAR level
measured for this device is less than 1.6 W/kg.
WiFi 5G indoor use only
Operations in the 5.15-5.25GHz band are restricted to indoor usage only.
1-5
CE Conformity
This device is in compliance with the essential safety requirements and other
relevant provisions set out in the European Directive.
Battery Regulations
European Union:
Batteries, battery packs, and accumulators should not be disposed of
as unsorted household waste. Please use the public collection system
to return, recycle, or treat them in compliance with the local
regulations.
Taiwan:
For better environmental protection, waste batteries should be
collected separately for recycling or special disposal.
California, USA: The button cell battery may contain perchlorate material and requires special
handling when recycled or disposed of in California.
For further information please visit: http://www.dtsc.ca.gov/hazardouswaste/perchlorate/
Safety Guideline for Using Lithium Battery
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the equipment manufacturer. Discard used batteries
according to manufacturer’s instructions.
Preface
1-6
WEEE Statement
Under the European Union ("EU") Directive on Waste Electrical and Electronic
Equipment, Directive 2002/96/EC, which takes effect on August 13, 2005,
products of "electrical and electronic equipment" cannot be discarded as
municipal waste anymore and manufacturers of covered electronic equipment
will be obligated to take back such products at the end of their useful life.
Safety Instructions
Read the safety instructions carefully and thoroughly. All cautions and
warnings on the equipment or user’s manual should be noted.
Keep this equipment away from humidity and high temperature.
Lay this equipment on a stable surface before setting it up.
The openings on the enclosure are used for air convection and to
prevent the equipment from overheating. Do not cover the openings.
Do not leave the equipment in an unconditioned environment with a
storage temperature above 60
which may damage the equipment.
This unit should be operated under maximum ambient temperature
O
C (120OF).
of 40
Make sure the power voltage is within safety range and has been
adjusted properly to the value of 100~240V before connecting the
equipment to the power outlet.
Always unplug the AC power cord before installing any add-on card
or module to the equipment.
O
C (140OF) or below 0OC (32OF),
1-7
Always disconnect the AC power cord or uninstall the battery pack
or switch off the wall socket if the equipment would be left unused
for a certain time to achieve zero energy consumption.
Never pour liquid into the opening that could damage the equipment or
cause an electrical shock.
Place the power cord in a way that people are unlikely to step on it. Do
not place anything on top of the power cord.
Always keep the strong magnetic or electrical objects away from the
equipment.
When installing the coaxial cable to the TV Tuner, it is necessary to
ensure that the metal shield is reliable connected to protective earthing
system of the building.
Cable distribution system should be grounded (earthed) in accordance
with ANSI/NFPA 70, the National Electrical Code (NEC), in particular
Section 820.93, Grounding of Outer Conductive Shield of a Coaxial
Cable.
If any of the following situations arises, get the equipment checked by a
service personnel:
The power cord or plug is damaged.
Liquid has penetrated into the equipment.
The equipment has been exposed to moisture.
The equipment has not worked well or you can not get it work
according to User’s Manual.
The equipment was dropped and damaged.
The equipment has obvious signs of breakage.
Green Product Features
Reduced energy consumption during use and stand-by
Limited use of substances harmful to the environment and health
Easily dismantled and recycled
Reduced use of natural resources by encouraging recycling
Extended product lifetime through easy upgrades
Reduced solid waste production through take-back policy
Preface
1-8 Environmental
Policy
The product has been designed to enable proper reuse of parts and
recycling and should not be thrown away
Users should contact the local authorized point of collection for
recycling and disposing of their end-of-life products.
Trademarks
All trademarks are the properties of their respective owners.
Revision History
Version Revision History Date
1.0 First Released 07, 2016
Loading...