Mobern Lighting RDIS Installation Instructions Manual

RDIS SERIES

Installation Instructions

• For information on how to recycle LED/Fluorescent electronic products, please visit
www.epa.gov

• Do not install damaged product. This xture is properly packed to prevent damage
during transit.

• All wiring connections should be capped with UL approved recognized wire
connectors.

• Do not touch LED diodes or any connecting clips; these parts are very sensitive.

• Do not exceeed maximum wattage marked on xture label.

Carefully read the instructions pertaining to your xture

thoroughly. IF YOU HAVE ANY QUESTIONS REGARDING
THE PROPER INSTALLATION OR LOCAL CODES,
CONSULT A QUALIFIED ELECTRICIAN.

Both cord set and hard wired xtures are intended for

connection to a grounded, three wire source of supply.

Do not install outdoors or in applications other than
intended use.

Ensure xture is properly grounded before testing. This xture is intended for dry applications only.

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTIONS AND
OPERATIONS OF THE PRODUCT AND THE HAZARDS INVOLVED.

RISK OF FIRE; MINIMUM OF 90°C SUPPLY CONDUCTOR SHOULD BE USED.
CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT
CONDUCTOR.

TO AVOID ELECTRIC SHOCK HAZARD, DISCONNECT THE POWER AT THE PANEL
BOARD (CIRCUIT BREAKER BOX) BEFORE BEGINNING INSTALLATION.

Injury to persons and damage to the xture and/or
mounting surface may occur if the xture is pulled from the
surface. To reduce risk of injury or damage, mount only to

a mechanically sound surface.

Install and wire the xture in locations in accordance with

all national, state and local codes.

To avoid shock hazard, do not work with live electrical

wires.

TO AVOID FIRE HAZARD RISK, WHEN INSTALLING HARD WIRED UNITS, BE AWARE
IF SUPPLY WIRES ARE LOCATED WITHIN THREE INCHES OF BALLAST. IF SO, USE
WIRE RATED FOR AT LEAST 90°C (194°F). IF UNSURE, CONSULT A QUALIFIED
ELECTRICIAN BEFORE INSTALLING.

8200 Stayton Dr., Suite 500 | Jessup, MD 20794 | Phone: [phone] Fax: [phone] | www.mobern.com

MOBERN LIGHTING

RDIS SERIES

Installation Instructions

8200 Stayton Dr., Suite 500 | Jessup, MD 20794 | Phone: [phone] Fax: [phone] | www.mobern.com

MOBERN LIGHTING