MMF POS Lockable Tablet Stand User Manual

Lockable Tablet Stand
Setup Sheet

Components Provided

Cash Drawer Top Surface
Mount Hardware Kit

Qty.: (3) #8 screws

(3) #8 nuts

Hardware is NOT included for any other mounting surfaces – screws need to suit specific desktop or platform thickness.

Tools Required

No tools required if used as a stand-alone solution

If stand will be bolted to a at surface:

• Pencil (to mark hole placement)

• 3/16"

drill bit (for cash drawer surface drilling)

• Phillips head screw driver and power drill will be required to mount stand to desired surface

Hardware is only provided for top of cash drawer integration.

Assembly Instructions

STEP 1

(Skip to STEP 2 if using as a stand-alone solution)
Firmly secure the base stand to a at surface with appropriate fasteners.

a. Three (3) #8 screws and three (3) #8 nuts are provided for

mounting stand on top surface of a cash drawer.
b. Remove the cash till and inner drawer from cash drawer housing.
c. Place stand on top of drawer and mark hole positions with pencil.
d. Drill holes on top of cash drawer.
e. Firmly secure the base by bolting three (3) screws through the

base plate and securing with nuts from under the top surface of

the cash drawer.

NOTE: Hardware is only provided for top of cash drawer integration.

Hardware is NOT included for any other mounting surfaces - screws
need to suit specific desktop or platform thickness.

STEP 2

Unlock the tubular lock cover located on the back side of the frame with
the keys provided. Remove lock cover.

STEP 3

Nest the tablet against the plate. Adjust the adaptable grips by
tightening the wing nut on the back side – bottom right corner to rmly
hold the tablet.

STEP 4

Replace the lock cover and engage the lock to secure the tablet.

Lockable Table Stand

(Holding tablet)

NOTE: Tablet not included

Lockable Table Stand

(Front view)

Adaptable
grip

Flat surface
mounting
holes (3)

Fixed grips

Base stand

Lockable Table Stand

(Back view)

Integrated
stand allows
360° rotation
for optimized
viewing angle
and orientation

®

Kensington
security slot

Cable
management
slot

STEP 2
High-security
tubular lock
with cover

Kensington is a registered trademark of its respective owner. MMF POS, MMF Industries
and Block and Company, Inc. are not associated with Kensington.

LckTabSetupSheet 532013300 8/14/14 ISO 9001-2008 1408119