Page 1
INSTALLATION & MAINTENANCE MANUAL
GROUND2
Page 2
GENERAL INSTRUCTIONS
These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance.
These instructions should be used to aid installation of the following product:
GROUND2
SAFETY
• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671)
and current Building Regulations. If in any doubt, consult a qualified electrician
• Please isolate mains prior to installation or maintenance
• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of the
circuit cable, fuse or circuit breaker
• Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for installation
• This product is Class I and must be earthed
• This product series is IP65 rated
INSTALLATION
• Provide power to the required point of installation (refer to BS7671 for correct cabling methods). Suitable IP
rated junction boxes should be used where required
• Round cable should be used for the mains supply. The use of flat cable will cause water ingress to the fitting.
The luminaire is supplied with an IP65 inline junction box allowing the termination of one 3-core flex up to
2
1.5mm
• Using the baseplate as a template, mark the location for, and drill the fixing holes ensuring not to infringe
with any gas / water pipes or electrical cables
Page 3
INSTALLATION & MAINTENANCE MANUAL
(BS7671) and current Building Regulations. If in any doubt , consult a qualified electrician
the circuit cable, fuse or circuit breaker
installation
Suitable IP rated junction boxes should be used where require d
fitting. The luminaire is supplied with an IP65 inline junction box allowing t he termination of one 3-core
flex up to 1.5mm
2
infringe with any gas / water pipes or electrical cables
Fig. 1
• Open the junction box attached to
the cable by unscrewing the four
screws on the lid (see Fig. 1)
• Connect the luminaire to the mains supply ensuring the correct polarity is observed: L - Live (brown), E Earth (green/yellow), N - Neutral (blue) (see Fig. 2)
Fig. 2
• Refit the lid of the junction box
• Fix luminaire to the desired surface using the fixings provided
• Insert 2 suitable GU10 lamps (max. 2 x 35W)
• Switch on and check for correct operation
Page 4
GENERAL
This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities
for where facilities exist.
Clean the external surfaces with a damp cloth using a mild solution of detergent and warm water only, do not
use aggressive cleaning products or solvents which may damage the product.
Do not use any source of high-pressure washers to maintain or clean this luminaire.
This product is dimmable dependent on lamp type.
WARRANTY
This product has a warranty of 1 year from date of purchase. Failure to install this product in accordance with
the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will
invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place
of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation
costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve
the right to alter product specification without prior notice.
Page 5
INTERNATIONAL
INTERNATIONAL
CONTACT DETAILS
INTERNATIONAL
CONTACT DETAILS
CONTACT DETAILS
ML Accessories Limited LU5 4LT
www.mlaccessories.co.uk
02
AKJUL21_V2
Loading...