MKT Fastening 3208000 User Manual
SAFETY DATA SHEET
2.2.
Label elements
- Liquid Roc 300 -
M10-3/8", M12-1/2", M16-5/8",
M20-3/4", M22-7/8", M24-1"
SECTION: 1. Product and company identification
1.1.Product identifier
Trade name/designation
1.2.Relevant identified uses of the substance or mixture and uses advised against
Specific use(s) : Building and construction work
1.3. Details of the supplier of the safety data sheet
Company
1.4. Emergency telephone number
Emergency telephone
: LR M10-3/8", LR M12-1/2", LR M16-5/8"
LR M20-3/4", LR M22-7/8", LR M24-1"
: MKT Fastening, LLC
1 Gunnebo Drive
Lonoke, AR 72086
T: 501-676-2222 / F: 501-676-2524
I: www.mktfastening.com / E: sales@mktfastening.com
: Chemtrec 800-424-9300
Page : 1 / 13
Revision nr : 1
Issue date : 21/09/2015
Supersedes :
SECTION: 2. Hazards identification
2.1.Classification of the substance or mixture
OSHA Regulatory Status : This material is classified as hazardous under OSHA regulations.
GHS-US classification Flam. Liq. 3
GHS-US classification Skin Irrit. 2
GHS-US classification Eye Irrit. 2A
GHS-US classification Skin
GHS-US classification STOT RE 1
Full text of H-statements: see section 16
Hazard pictograms (GHS-US)
Signal word (GHS-US)
Hazard statements (GHS-US)
Precautionary statements (GHS-US)
:
:
:
:
Sens. 1
GHS02 GHS07 GHS08
Danger
Flammable liquid and vapor
Causes skin irritation
May cause an allergic skin reaction
Causes serious eye irritation
Causes damage to organs through prolonged or repeated exposure
P210 - Keep away from heat/sparks/open flames/hot surfaces. - No smoking.
Wear protective gloves/protective clothing/eye protection/face protection.
IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse
skin with water/shower
If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if
present and easy to do. Continue rinsing
2.3.Other hazards
Other hazards which do not result in
classification
: Not applicable
SAFETY DATA SHEET
Substance name
CAS No.
%
Page : 2 / 13
Revision nr : 1
Issue date : 21/09/2015
- Liquid Roc 300 -
Supersedes :
M10-3/8", M12-1/2", M16-5/8",
M20-3/4", M22-7/8", M24-1"
SECTION: 3. Composition/information on ingredients
Styrene 100-42-5 1 - 12,5
Dibenzoyl peroxide 94-36-0 0,5 - 2,5
1,1'-(p-tolylimino)dipropan-2-ol 38668-48-3 0 - 0,75
SECTION: 4. First aid measures
4.1.Description of first aid measures
Inhalation : Provide fresh air.
Put victim at rest, cover with a blanket and keep warm.
In case of doubt or persistent symptoms, consult always a physician
Skin contact : Remove contaminated, saturated clothing immediately.
After contact with skin, wash immediately with plenty of water .
Call a physician if irritation develops or persists.
Eye contact : Rinse immediately with plenty of water, also under the eyelids, for at least 15
minutes.
In case of doubt or persistent symptoms, always consult a physician
In case of ingestion : Get medical advice/attention
Additional advice
: First aid provider: Pay attention to self-protection!
See also section 8
Never give anything by mouth to an unconscious person or a person with
cramps.
Show this safety data sheet to the attending doctor.
Treat symptomatically.
4.2.Most important symptoms and effects, both acute and delayed
Inhalation : No adverse effects are expected. May be irritating.
Skin contact : Causes skin irritation. May cause an allergic skin reaction.
Eye contact : Causes serious eye irritation.
Ingestion : No adverse effects are expected.
Other adverse effects : Causes damage to organs through prolonged or repeated exposure.
4.3.Indication of any immediate medical attention and special treatment needed
No data available
SECTION: 5. Firefighting measures
5.1.Extinguishing media
Suitable extinguishing media : Water spray, Alcohol resistant foam, Carbon dioxide, Dry extinguishing
powder
Extinguishing media to avoid : Strong water jet
5.2.Special hazards arising from the substance or mixture
Fire hazard
Specific hazards : Hazardous decomposition products COx.
5.3. Advice for firefighters
Advice for firefighters : Special protective equipment for firefighters.
: Flammable liquid and vapor.
Do not allow run-off from fire-fighting to enter drains or water courses.
Dispose of waste in accordance with environmental legislation
SAFETY DATA SHEET
Styrene (100
-42-5)
Page : 3 / 13
Revision nr : 1
Issue date : 21/09/2015
- Liquid Roc 300 -
Supersedes :
M10-3/8", M12-1/2", M16-5/8",
M20-3/4", M22-7/8", M24-1"
Use water spray or fog for cooling exposed containers
Keep away from heat, hot surfaces, sparks, open flames and other ignition
sources. No smoking.
No smoking.
Do not allow run-off from fire-fighting to enter drains or water courses.
Dispose of waste in accordance with environmental legislation
SECTION: 6. Accidental release measures
6.1.Personal precautions, protective equipment and emergency procedures
For non-emergency personnel : Evacuate personnel to a safe area
Use personal protective equipment as required.
Reference to other sections: 8
Provide adequate ventilation
Avoid contact with skin, eyes and clothing
Do not breathe vapors/dust.
Keep away from heat, hot surfaces, sparks, open flames and other ignition
sources. No smoking.
Ensure equipment is adequately grounded
Take precautionary measures against static discharges
Do not allow to enter into surface water or drains
For emergency responders : Ensure procedures and training for emergency decontamination and disposal
are in place
Concerning personal protective equipment to use, see section 8.
6.2.Methods and material for containment and cleaning up
Spill or leak statements by chemical : Use appropriate personal protection equipment (PPE).
Exclude sources of ignition and ventilate the area
Prevent runoff from entering drains, sewers or waterways.
Collect in closed and suitable containers for disposal.
SECTION: 7. Handling and storage
7.1.Precautions for safe handling
Advices on general occupational hygiene : Keep good industrial hygiene
Wash hands and face before breaks and immediately after handling of the
product.
Take off contaminated clothing.
7.2.Conditions for safe storage, including any incompatibilities
Storage : Keep container tightly closed in a cool, well-ventilated place.
Keep away from heat, hot surfaces, sparks, open flames and other ignition
sources. No smoking.
Keep away from food, drink and animal feedingstuffs
Keep at temperatures below 25 °C.
Keep away from heat
Protect from sunlight.
Do not store near or with any of the incompatible materials listed in section
10.
SECTION: 8. Exposure controls/personal protection
8.1. Exposure guidelines
ACGIH ACGIH TWA (ppm) 20 ppm
ACGIH ACGIH STEL (ppm) 40 ppm
SAFETY DATA SHEET
Styrene (100
-42-5)
Dibenzoyl peroxide (94
-36-0)
:
Page : 4 / 13
Revision nr : 1
Issue date : 21/09/2015
- Liquid Roc 300 -
Supersedes :
M10-3/8", M12-1/2", M16-5/8",
M20-3/4", M22-7/8", M24-1"
IDLH US IDLH (ppm) 700 ppm
NIOSH NIOSH REL (TWA) (mg/m³) 215 mg/m³
NIOSH NIOSH REL (TWA) (ppm) 50 ppm
NIOSH NIOSH REL (STEL) (mg/m³) 425 mg/m³
NIOSH NIOSH REL (STEL) (ppm) 100 ppm
OSHA OSHA PEL (TWA) (ppm) 100 ppm
OSHA OSHA PEL (Ceiling) (ppm) 200 ppm
Québec VECD (mg/m³) 426 mg/m³
Québec VECD (ppm) 100 ppm
Québec VEMP (mg/m³) 213 mg/m³
Québec VEMP (ppm) 50 ppm
ACGIH ACGIH TWA (mg/m³) 5 mg/m³
IDLH US IDLH (mg/m³) 1500 mg/m³
NIOSH NIOSH REL (TWA) (mg/m³) 5 mg/m³
OSHA OSHA PEL (TWA) (mg/m³) 5 mg/m³
Québec VEMP (mg/m³) 5 mg/m³
8.2. Engineering controls
Engineering control measures : Use only in area provided with appropriate exhaust ventilation.
Take precautionary measures against static discharge
Emergency eye wash fountains and safety showers should be available in the
immediate vicinity of any potential exposure
Organizational measures to prevent /limit releases, dispersion and exposure
See also section 7
Environmental exposure controls : Do not allow contact with soil, surface or ground water.
Comply with applicable Community environmental protection legislation.
8.3. Personal protective equipment (PPE)
Personal protection equipment : The type of protective equipment must be selected according to the
concentration and amount of the dangerous substance at the specific
workplace.
Respiratory protection
Hand protection : Wear chemically resistant gloves. Impervious gloves Butyl caoutchouc (butyl
Eye protection : Safety glasses
Body protection : Wear suitable protective clothing.
Thermal hazard protection : Not required for normal conditions of use
In case of insufficient ventilation, wear suitable respiratory equipment
Full face mask
Half face Air-Purifying
Filter type: A
rubber) Breakthrough time (maximum wearing time) : > 120 min The selection
of specific gloves for a specific application and time of use in a working area,
should also take into account other factors on the working space, such as (but
not limited to): other chemicals that are possibly used, physical requirements
(protection against cutting/drilling, skill, thermal protection), and the
instructions/specification of the supplier of gloves.
SECTION: 9. Physical and chemical properties
9.1.Information on basic physical and chemical properties
Appearance : capsules
Loading...