MK Sound INWALLS MOUNTING TEMPLATE User Manual

LEVEL TO THIS LINE

TRACE AROUND THIS TEMPLATE

Wall cutout for

SW-95/SW-62/BE-65

in-wall speaker

10-9/16"

(26.8cm)

IMPORTANT! - MAKE SURE WALL ELECTRICITY IS

!

TURNED OFF BEFORE STARTING INSTALLATION

1. Mark wall with template, using a stud finder

to maintain a 2" distance from any stud. Make
sure that you are clear of any crossbraces in
the wall structure.

FOR STANDARD INSTALLATION
DRYWALL THICKNESS CANNOT
EXCEED 1.25 INCHES.
FOR THICKER WALLS CALL
M&K SOUND.

4. Tape speaker wire to the back wall so the
end is within the opening as shown.

5. Fold the first section of the foam strip and
insert the corner through the wall opening.

speaker
wire

2. Cut opening precisely with drywall
saw, drywall router, etc. Sand edges
and clean debris from installation area.

6. Continue folding and inserting the rest
of the foam strip into the wall opening
until the foam frame is created.

7. Make sure that the frame is centered
within the opening

3. Use the included foam strip to fill in
the wall space around the speaker.
The foam strip has 1"deep slits
to allow bending it into a 4-sided frame.

Be careful when bending and handling
the strip so that you do not rip it.

8. Mount the adhesive backed foam
pad in the wall approximately five
inches above the bottom of the
cutout. This puts the foam behind
the woofer.

Note: Do not put any other acoustic
filler within the wall opening as it can
interfere with speaker mounting.

!

PN: 70306
SW95/SW62/BE65 cutout temp
08/26/02  pt

7-1/4"

(18.4cm)