Mk electric LOGIC PLUS SHAVER SOCKET OUTLET DATASHEET

TECHNICAL DATA SHEET

Logic Plus

Shaver Socket Outlet

1:1

Logic Plus™ Shaver Socket Outlet

PRODUCT RANGE

Shaver socket outlet
200-250 volt input K700 WHI

Standards and approvals

Shaver socket outlets comply with
BS 4573: 1970 and IEC 884-1: 1994.

Plug pin apertures, and engagement face dimensions
comply with BS 4573: 1970.

TECHNICAL SPECIFICATION

Electrical

Voltage rating:
200-250V a.c. Input

Maximum load:
200 mA (internal thermister trip current)

Terminal capacities:
Each terminal will accommodate 1 x 4mm
or 2 x 2.5mm2, 3 x 1.5 solid conductors

Physical

Ambient operating temperature:
–5°C to +40°C

IP rating:
IP4X

Max. installation altitude:
2000 metres

2

,

Description

Designed for ease of installation and having
many of the advantageous features of the
Logic Plus range.

The shaver socket outlet accommodates the
following plugs:

British 5mm dia pins on 16.6mm pitch (230V
socket) to BS 4573: 1970.

European 4mm dia pins on 17 to 19mm pitch
(230V socket) to IEC 83: 1975 Standard C5.

Features

I Top access terminals make wiring

quicker and easier

I Only one size of screwdriver required

for installation

I Terminal screws supplied ‘backed out’

and held captive within the terminal
moulding

Installation

Shaver socket outlets may be wall or bench
mounted.

This shaver socket must not be used in
bathrooms and washrooms. Non-isolated,
fused, shaver socket outlets must never be
installed in any location subject to splashes,
condensation or damp conditions.

For installation in any other room where a
wash basin or shower cubicle is installed then
refer to BS7671 IEE wiring regulations.

Cable Management

Logic Plus socket outlets can be mounted in a
variety of MK trunking systems.

See MK catalogue for further details.

Australian 6.5 x 1.6 flat blades each set at 30°
to the vertical on a nominal pitch of 13.7mm
(230V socket) AS C112: 1964.

The fuse carrier is captive and opened by a
fast acting, screwdriver operated worm drive
screw for ease of replacement.

I White printed terminal markings on

grey rear mouldings for clearer
identification

I Front plate fixing screws retained on

rear case moulding

Dimensions (mm)

86

86

shavers only

200 - 250V ac

fuse

fuse

60.3

9

20

Box types

Flush mounting 861 ZIC

minimum metal
mounting box
depth is 25mm

Flush mounting K2140

32mm deep

©2002 MK Electric Limited The Arnold Centre, Paycocke Road, Basildon, Essex SS14 3EA, United Kingdom Tel: [phone] Fax: [phone] email: [e-mail] www.mkelectric.co.uk Edition 06-02