MJX T10 SHUTTLE, T11 SHUTTLE User guide

Page 1

Ages14+

INSTRUCTION MANUAL

MODEL:T10 SHUTTLE / T11 SHUTTLE DIGITAL PROPORTIONAL R/C COAXIAL HELICOPTER

Please read the instructions carefully before use and retain it for future reference.

Page 2
TECHNICAL PARAMETER OF THE HELICOPTER
T10 Fuselage Length: 500mm Gross Weight:438g Tail Rotor Diameter:90mm
T11 Overall Height: 235mm Motor:Model#180 Battery: Li-Polymer 7.4V1100mAh
Main Rotor Diameter:490mm Gear Ratio:14:1 Charging Time: About 2.5 Hours
WARNING

  • *Users are responsible for not causing injuries to people or damages on others' property when playing the helicopter.
  • *Users should strictly follow the instructions when installing and debugging the helicopter. Ensure that your body is away from the steering parts of the helicopter; otherwise, it would bring serious damage to the helicopter or even injuries to your body.
  • *The users are in full charge of proper operating the helicopter. The manufacturer and dealers disclaim all responsibility for the damage caused by misuse.
  • *This product is not applicable for children who are under 14 years old.
  • *Please correctly install the helicopter and play it under the guidelines of the instruction manual, small parts should be assembled by an adult.
  • *The product contains small parts, please guard against eating by mistake and choking hazard.
  • *Prohibit playing this helicopter on the road or near pool.
  • *Please put away the package material to avoid injury on children.
  • *Please keep regularly check on the charger, wire, plug, the fuselage cover and other parts. If damages are found, users should stop playing until it is well repaired.
  • *The charger should be connected to the proper voltage as indicated.
  • *Only the charger provided by the manufacturer can be used.
  • *The charger is not a toy.

  • *When cleaning the helicopter, please ensure that the helicopter is disconnected with the charger.
  • *Please do not point the antenna directly to your faces, eyes or other people in case of injury.
  • *"AA"non-rechargeable battery or"AA" rechargeable battery is applicable.
  • *Non-rechargeable batteries are not to be recharged.
  • *Rechargeable battery is only to be charged under adult's supervision.
  • *Only batteries of the same or equivalent type as recommended are to be used.
  • *Batteries are to be inserted with correct polarity.
  • *Exhausted batteries are to be removed from the battery compartment.
  • *The supply terminals are not to be shortcircuited.
  • *Do not short circuit, decompose the battery or throw it into fire.
  • *Do not mix old and new batteries.
  • *Do not mix alkaline batteries, standard (carbon-zinc) or rechargeable (Nickel-Cadmium) batteries.
  • *Please take out the batteries when not in use.
  • *Photos are for reference only; the appearance of the actual product is base on what it is.
  • *Different types of batteries are not mixed.
  • *Rechargeable batteries are to be removed from the toy before being charged.
  • *Please retain this information for future reference.
  • When the controller/helicopter is underpowered, the control distance would be shortened due to this effect.
  • If the helicopter is underpowered, it would result in difficulty of taking off or lower flight altitude.
  • If the helicopter is damaged or become deformed, please repair it intime. If it is seriously damaged (e. g. the rotor of the helicopter is ruptured), user should stop playing; otherwise, it may get the user injured.
  • If you do not play the helicopter for a long time, please take out the batteries from the controller to avoid battery leakage which would damage the product.
  • Please do not have the helicopter fell from high altitude or crashed. It would make the helicopter broken of greatly reduce the service life of the helicopter.
    • 2
Page 3

PRODUCT/SPARE PARTS INCLUDED IN THIS PACKAGING

Main Units & Accessories
Description Qty (pcs)
Helicopter 1
Rechargeable Battery Pack 1
Charger 1
Main Units & Accessories
Description Qty (pcs )
Manual 1
Remote Controller 1
Antenna 1
Control Stick 2

ASSEMBLING THE REMOTE CONTROLLER AND CHARGING THE BATTERIES

Trimmer

1. Insert the antenna into the small hole locating at the top of the remote control unit. Screw it until it is well tighten by turning clockwise . Insert the two control sticks into the holes locating at the left and the right side of the remote controller respectively. (Pic.1)

ight Switch

Professional

/Normal Switch

2. Installing the Batteries: Open the battery compartment cover by turning the battery compartment screw counterclockwise. Insert 3X"AA "batteries into the battery compartment. Ensure the batteries are inserted properly by matching the "+"and"-" symbols as indicated. (Pic.2)

Page 4

3. Charging the battery:

  • Slide the power switch of the helicopter to "OFF" position.
  • Unplug the plug of the battery cable from the battery connecting socket of the helicopter.
  • Insert the plug of the battery cable into the port of the charger (matching the plug to the port). Then, connect the plug of the charger to AC power outlet.
  • Full charging takes about 2.5 hours(It is not advisable to charge the battery for an excessive length of time).
  • Overcharging will damage the battery.

Pic.3

When not playing the model, please turn off the model and unplug the battery cable from the socket. If it keeps connected, it may result in over discharging. Take out the batteries from the remote controller while not playing the model for a long time.

▲ NOTE

NOTE ON THE BATTERY

This product is furnished with battery pack, please pay attention to the following safety instructions:

  • ① Only the charger provided by the factory could be used for charging.
  • 2 When charging the battery: If the battery is too hot, it means that the battery is overcharged. In such case, users should stop the battery charging right away. Over charging would damage the battery eternally.
  • ③ Please keep supervised when charging the battery.
  • (4) Do not decompose the battery.
  • 6 After finishing flying, the battery temperature would be relatively high. Users are advised to wait for about 30 minutes until the battery is chilled down before recharging.
  • 6 Please turn off the helicopter if not using. If you are planning not to play the helicopter for a long time, charge the helicopter for about 1 hour before storing it .

Caution : Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. For adaptor, the socket-outlet shall

For adaptor, the socket-outlet shall be installed near the equipment and shall be easily accessible

FLIGHT ENVIRONMENT

  • ① Sunny and windless weather is suitable for the helicopter flying. *Do not play the helicopter where the temperature is higher than 113°F (45°C) or lower than 50°F (10°C).
    • *Do not play the helicopter in strong wind weather as the wind would cause control limitation and hinder the flying control. Moreover, the helicopter would be damaged or even disappear due to the strong wind weather.
  • ② Please choose a wide and open area for playing the helicopter and make sure that there is no barrier, no animals and people nearby when playing.

CAUTIONS

Please do not touch the high-speed rotating parts including the gear and main rotor, when the model is activated.

Page 5

PREPARATION FOR FLIGHT

Must set the remote controller to the "OFF" position before operating step 1

  • 1. Turn on the helicopter by inserting the battery plug into the battery socket, the helicopter light will keep quickly blinking for about 3 seconds while the helicopter is checking the middle point of the gyro. Then, the light of the helicopter will blink slowly, indicating that the helicopter is ready to connect with the remote controller.
  • 2. Turn on the remote controller, the power indicator light of the remote controller will blink slowly, slowly push up the throttle control stick to the top and then push it down to the bottom. Then, remote controller sends out connectional signal and the indicator light keep quickly blinking during the signal connection process. Once signal connection is done, the light of the helicopter and the power indicator light of the remote controller will stay "ON" without blinking, meaning that the helicopter is ready for flight.
  • 3. Push up the throttle stick and the helicopter takes off.
OPERATING

Press "EXIT/LIGHT" to turn on or turn off the searchlight. The light makes the helicopter look more attractive at night flight.

Page 6

Page 7

FLIGHT PRACTICE

After enough practice, you can try the following flight ways:

Rotates around the rotation axis

Fly ahead-Turn left-heading-Turn left-heading-Turn left, Try to fly in a quadrate. Repeat the practice until you could control the helicopter to fly in a circle.

TROUBLE SHOOTING
Before asking for service, check the following first.
Phenomenon Causes Solution
The helicopter is underpowered. Get the battery of the helicopter charged.
No reaction from the The remote controller is underpowered. Replace with new batteries of the remote controller.
helicopter. The remote controller has not been started. Re-start the remote controller
The indicator light of the helicopter blinks very quickly. Set the helicopter down to the ground and wait until the indicator light stay "on" without blinking.
The distance between the helicopter and the remote controller is too long. Shorten the The distance between the helicopter and the remote controller.
The helicopter flys intermittently. Another remote controller nearby is sending
out signal of the same frequency
Change another place where there is no interference.
The antenna is not extendede to the longest. Extended the antenna to its longest

Loading...