Mixlinker APRUS II Operation Manual
TM
APRUS II
Operation Manual
Mixlinker Networks (Shenzhen) Inc.
Warning
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
1)Reorient or relocate the receiving antenna.
2)Increase the separation between the equipment and receiver.
3)Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
4)Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer
could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
To comply with FCC RF exposure compliance requirements,this grant isapplicable to only
mobile configurations. The antennas used for this transmittermust be installed to provide a
separation distance of at least 20 cm from allpersons and must not be co-located or
operating in conjunction with any otherantenna or transmitter.
Contents
I. Introduction ------------------------------------------------------------- 01
II. Nomenclature --------------------------------------------------------- 02
III. Packing List ------------------------------------------------------------ 03
IV. Specification ---------------------------------------------------------- 03
V. Interfaces ---------------------------------------------------------------- 04
VI. Indicators -------------------------------------------------------------- 08
VII. Connections ---------------------------------------------------------- 09
VIII. Installation ----------------------------------------------------------- 10
IX. FCC Warnning --------------------------------------------------------- 12
I. Introduction
Welcome to use the Advanced Programmable Remote Utility
Server (APRUS II) of Mixlinker Network (Shenzhen) Inc. (herafter
referred to as Mixlinker).
APRUS is an advanced programmable Internet of Things
adaptor for industrial equipment developed by Mixlinker.
APRUS II is the second generation product of Mixlinker, and
will be referred to as APRUS II.
APRUS II is an intermediate adapter developed to address
theneeds of traditional equipment for IoT. Adaptors are used
to establish data communication with equipment (controller)
without making changes to equipment, by way of adapting, to
send the operation status and data to IoT platform, so as to
make the right judgement and take right action to reduce the
malfunction of equipment, lowing operation cost. This manual
briefly introduces APRUS II to customers, and provide
help to customers for using the product.
01
Product Info
Mixlinker
Adva
nce
d
Progra
mmable Remote
Ut
ility Server (
APRUS II)
4
GPS
Modules
2
Module with GPS
A2 -
4207
- B
Communication Modules
2G Communication Module
Power Input
AC/DC 24V Input
Interfaces
0
CAN,RS485-1,RS485-2
02
II.
Nomencl
atur
e
Loading...