Page 1
User Manual
Product Name Contactless Smart Card Reader
Model RDFL-B03H/ RDFL-B03BLE/ RDFL-B03BLES
Ver.1.0
Apr. 8, 2019
MIWA LOCK CO., LTD.
Page 2
User Manual
Specifications
Model
RDFL-B03H （Mifare Type）
RDFL-B03BLE (Mifare and BLE Type)
RDFL-B03BLES (Mifare and BLE Type) with Diffuse
reflection photoelectric sensor
Dimensions
Panel
116(W) , 120(H) , 7(D)
Main body
90(W) , 70(H) , 35(D)
Weight
250g approximately
Materials
Panel : Acrylic
Main body : ABS resin
Power supply
supplied from a controller
Operation temperature
-10～50℃
Safekeeping temperature
-10～60℃
Operation humidity
20～90%RH Without condensation
Target card
ISO14443 TYPE A (MIFARE)
1. APPLICATIONS
This manual explains the contactless smart card readers "RDFL - B03H", "RDFL - B03 BLE" and
RDFL-B03BLES which are readers exclusively for the card key of the hotel card lock "ALV2". These will
manage guest rooms and hotel facilities.
Model：RDFL-B03H ・・・ Only Mifare Card can be used
Model：RDFL-B03BLE ・・・ Mifare Card and Bluetooth Low Enagy (BLE) can be used
Model：RDFL-B03BLES ・・・ Mifare Card and Bluetooth Low Enagy (BLE) can be used with Diffuse
reflection photoelectric sensor
2. SUMMARY
2-1.Contactless Smart Card Reader
(1) It is a card reader dedicated to the entrance of the hotel card lock "ALV2" which reads and
outputs Mifare card or smartphone authentication key.
(2) When using a contactless smart card or a smartphone authentication key issued from an issuing
device installed in the front desk, various information such as a hotel code and a room number
are collated with the stored data. If it is confirmed that the card is valid, it outputs a signal to the
external system.
3. GENERAL SPECIFICATIONS
MIWA LOCK CO., LTD. 2
Page 3
User Manual
4. Detail of function
(1) Bring a card key or smartphone close to the contactless smart card reader.
(2) The contactless smart card reader reads the key data and if the data accords with the database,
signal is sent the external system.
Collation data:
1) Hotel code
2) Validity of the card key or authentication key. (from check-in time to check-out time)
3) Room number of the key.
(3)If the card key is valid, the LED lights blue. In case of invalid card key, the LED lights red.
MIWA LOCK CO., LTD. 3
Page 4
User Manual
5. Regulatory Compliance
Caution:
Any changes or modifications not expressly approved by the party responsible for
product compliance could void the user's authority to operate the unit.
5-1. USA-Federal Communications Commission (FCC)
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This unit complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This unit may not cause harmful interference, and
(2) This unit must accept any interference received, including interference that may
cause undesired operation.
・Responsible Party – U.S. Contact Information
MIWA Irvine, CA Office
9272 Jeronimo Road, Suite 119, Irvine, CA 92618
Telephone：1-949-328-5280 / FAX：1-949-328-5281
MIWA LOCK CO., LTD. 4
Page 5
User Manual
5.2. Innovation, Science and Economic Development Canada （ISED）
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1)This device may not cause interference.
(2)This device must accept any interference, including interference that may cause
undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
(1)L’appareil ne doit pas produire de brouillage;
(2)L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
6. Labeling
MIWA LOCK contactless smart card reader is labelled below.
･RDFL-B03H(Mifare type)
FCC ID：VBU-RDFLB03H
IC：21683-RDFLB03H
･RDFL-B03BLE and RDFL-B03BLES(Mifare and BLE type)
FCC ID：VBU-RDFLB03H
IC：21683-RDFLB03H
Contains FCC ID: VPYLBZY
Contains IC: 772C-LBZY
MIWA LOCK CO., LTD. 5
Loading...