RAM SHAFT
SHOULDER BOLT
PRESS FRAME
RAM SHAFT
ASSEMBLY INSTRUCTIONS FOR HYDRAULIC PRESS
STEP #1 REMOVE SHOULDER BOLT AND
DROP RAM SHAFT OUT THE BOTTOM.
STEP #2 THREAD HYD. CYL. ONTO PRESS
FRAME TIGHTEN SECURELY.
STEP #3 INSTALL RAM SHAFT TO
HYDRAULIC CYLINDER & TIGHTEN
SECURELY. BE SURE THREADED HOLE FOR
SHOULDER BOLT IS VISIBLE IN THE SLOT.
HYDRAULIC
CYLINDER
THREADED
HOLE
STEP #4 INSTALL SHOULDER BOLT &
TIGHTEN SECURELY.
STEP #5 INSTALL PRESS TOOLING TO SUIT. DO NOT OVER POWER PRESS AS DAMAGE
COULD OCCUR TO PRESS, AND / OR TOOLING AND CAUSE PERSONAL INJURY!
\\Mbserver01\Engineering\Product\Product Documentation\2200 Bench Press\Hydraulic Press Assm Instructions .Doc REV 2.00 3/27/2004 JEP
Loading...