ASSEMBLY INSTRUCTIONS FOR
DIGITAL READOUT
DISASSEMBLE READOUT & GUARD FROM TUBE
STEP #1 PLACE STEEL
TUBE OVER GEAR RACK.
2500-020
2500-019
- 1 -
2500-021
STEP #2 INSTALL 4 1/4-20 STEP #3 INSTALL ALUMINUM
SHCS AND TIGHTEN DOWN. BRACKET THRU TOP OF SLOT.
2500-501
2500-019
2500-020
1-800-467-2464
\\Mbserver01\Engineering\Product\Product Documentation\2500 180 HYD Bender\ASSEMBLY INSTRUCTIONS OF 180 DIGITAL
READOUT.doc Rev. 2.00 11/17/04 JEP
- 2 -
STEP #5 INSTALL 1/4-20 SHCS
AND WASHER THRU ACCESS
HOLE IN SIDE OD TUBE INTO
STEP #4 SLIDE BRACKET SLOT IN THE ALUM BRACKET.
OVER TOP OF GEAR RACK. DO NOT TIGHTEN!
STEP #7 SET DIGITAL
RE A DOUT SCALE ON TOP
STEP #6 SET THE 2 ALUM OF ALUM SPACERS WHILE
SPACERS ON TOP OF TUBE ALIGNING THE 1/8 DIA PIN
OVER THE 10-32 TAPED WITH THE DRIVE SLOT ON
HOLES. THE BRACKET.
2500-021
2500-501
1-800-467-2464
\\Mbserver01\Engineering\Product\Product Documentation\2500 180 HYD Bender\ASSEMBLY INSTRUCTIONS OF 180 DIGITAL
READOUT.doc Rev. 2.00 11/17/04 JEP
- 3 -
STEP #9 SLIDE READER HEAD
TOWARD MACHINE UNTIL IT
STOPS. THEN TIGHTEN
STEP #8 TIGHTEN DOWN DOWN THE 1/4-20 SHCS THRU
THE 2 10-32 SHCS THAT ACCESS HOLE ON THE SIDE OF
MOUNT THE SCALE. THE TUBE.
STEP #10 INSTALL THE
COVER-GUARD OVER
DIGITAL READOUT WITH
6 1/4-20 BSHCS AND WASHERS.
1-800-467-2464
\\Mbserver01\Engineering\Product\Product Documentation\2500 180 HYD Bender\ASSEMBLY INSTRUCTIONS OF 180 DIGITAL
READOUT.doc Rev. 2.00 11/17/04 JEP
Loading...