Page 1
Page 2
vehicle.
may be required to remove the cotter pin
and lock nut assembly to expose the threads.
determine how much camber you have.
Read to the center of the bubble.
do not have turn plates, the end of the gauge has been
machined with 20 degree angles for a easy reference.
This machined area will be parallel with the centerline
or side of your vehicle.
adjust this until your caster vial (center vial) reads 0.
will now have moved the wheel through 40 degrees of
rotation. Level the gauge by the end level vial.
caster.
You may do so by checking the level vial.
Loading...