MITSUBISHI ELECTRIC ITAMI WORKS IPS280 User Manual

DWG# : INS2019-002

C

SCOPE

This datasheet & manual specify the K band RF front-end module to apply vehicle (including train

vehicle) mounted velocity meter

Since this device is always used with vehicle, it is not sold to general end users separately. Therefore

there is no user manual of this device by alone.

PARTS NUMBER AND DESCRIPTION

Parts#

Region

Certification ID

IPS-280

USA

2ARCVIPS280

JAPAN

REMARK

Region Representative / Reseller PTM Corporation is responsible to every technical question except
manufacturing confidential. All the inquiries should be forwarded to representative.

Supplier /Representative PTM Corporation TEL: [phone]

DWG# : INS2019-002

Define & Design support PTM Corporation,.

Page- 7 / 8

ANNEX

The information that will be given below is only a rough overview; for details please contact the local approval
agencies. An overview over the frequency bands in Europe can also be found in the REC 70-03 (Annex 6)

which is available under www.ero.dk

➢ Frequency Bands in US FCC 15.245

For the US-market IPS-280 can be used

➢ FCC caution: Changes or modifications made to this equipment not expressly approved by InnoSenT

GmbH may void the FCC authorization to operate this equipment.

➢ Manufacturers of mobile or fixed devices incorporating IPS-280 Modules are authorized to use the

FCC

➢ Grants for their own final products according to the conditions referenced in these documents. In this

case, the FCC label of the module shall be visible from the outside, or the host device shall bear a

second label stating Contains FCC ID: 2ARCVIPS280“

➢ Following statements must be included in the instruction manual of host device.

FCC approval
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

NOTICE:

Changes or modifications made to this equipment not expressly approved by (manufacturer name) m ay void

the FCC authorization to operate this equipment