Mitsubishi R4A51, V4A51, R4A3, AW372, KM148 User Manual
...
MITSUBISHI
REAR WHEEL DRIVE
AUTOMATIC TRANSMISSION
WORKSHOP MANUAL
FOREWORD
This Workshop Manual contains procedures for
removal, disassembly, inspection, adjustment, reassembly and installation, etc. for service mechanics.
All information, illustrations and product descriptions contained in this manual are current as at the
time of publication. We, however, reserve the right
to make changes at any time without prior notice or
obligation.
FILING INSTRUCTION
Please keep these manual pages in the binder No.
BN940001.
File these pages according to the signs “Added”,
“Revised” and “Deleted” on the “List of effective
pages” which are interpreted below.
Added:
Revised. Deleted:
File the pages with this sign additionally
in your manual.
Replace the existing pages
with the corresponding pages having
this sign.
Automatic Transmission
R4AW2, V4AW2
Automatic Transmission
R4AW3, V4AW3
Automatic Transmission
V4AW4
Automatic Transmission
R4A51, V4A51
Automatic Transmission
V5A51
............
............
............
............
............
23A
23B
23C
23D
23E
Missing sheets will be supplied upon request.
Mitsubishi Motors Corporation
E
July 2000
Pub. No. PWEE8920-J
HOW TO USE THIS MANUAL
CONTENTS
The preceding page contains GROUP INDEX which
lists the group title and group number.
PAGE NUMBERS
All page numbers consist of three sets of digits separated by a dash. The digits preceding the dash identify the number of the group and the second digits
identify the section. The digits following the dash represent the consecutive page number within the section. The page numbers can be found on the top left
or right of each page.
TEXT
Unless otherwise specified, each service procedure
covers all models. Procedures covering specific
models are identified bythemodelcodes, destination
or similar designation (engine type, transmission
type, etc.)
SERVICE PROCEDURES
The service steps are arranged in numerical order
and attentions to be paid in performing vehicle service are described in detail in SERVICE POINTS.
Denotes tightening torque
NOTE:
D
Torque may also be shown in
rectangles in the order of
units (Nm, kgm and ft-lbs.
from left) as follows.
33 3.3 23
D
From January 1999 on,
torque values are given only
in SI unit.
Loading...