Mita-Kyocera FS-9100, FS-9500 PARTS LIST 015

Service Bulletin

1 / 2

SB Number: SB 2BJ-015

Issue Date: 21/08/2002

Subject: Black spots on image (drum pinholes / charger leak)
Model: KM-2530 / 3530, FS-9100DN / 9500DN

Phenomenon

Pinholes may occur on the drum which may lead to black spots on the image.

Cause

If the separation section becomes dirty due to paper dust, toner etc., the separation voltage becomes high
and charge leaks to the drum via the ‘BRUSH SEPARATION’.

Countermeasure

In order to prevent the occurrence of charge leakage as much as possible, the limit value has been
changed as follows.

l D155 rated voltage has been changed from 18V to 15V.
l Limit value of separation output voltage on ‘HIGH VOLTAGE PCB’ has been changed as follows:

OLD 5.4 KV to 6.0 KV NEW 4.1 KV to 4.7 KV

Field Measure

Please instruct the user to clean the ‘BRUSH SEPARATION’ as mentioned in procedure on page 2 of this
bulletin. Check and clean during next maintenance or service visit.

HIGH VOLTAGE PCB

D155

18V → 15V

Parts Table

No.

Part No.

OLD

1 2BL28050 2BL28051 HIGH VOLTAGE PCB 1 1 X O

The new High voltage PCB’s last letter of lot number is ‘E’.

Part No.

NEW

Affected Machine Serial Numbers:

KM-2530: AAH3006689 and later
KM-3530: AAJ3006016 and later

FS-9100DN: XRX2300218 and later
FS-9500DN: XAJ1Y00286 and later

Description

‘BRUSH SEPARATION’ (P/N: 2BL17110)

Q’ty

old-new

Interchange-

ability

KMIS Service Team, Kyocera Mita Europe 5425 / SB 2BJ-015

Service Bulletin

Cleaning

separation claw



2 / 2

Please instruct the user to clean the ‘BRUSH SEPARATION’ (separation claw) as follows.

1. Open the front cover.

2. Take cleaning brush from below location in machine.

3. Pull out lock lever, and open left cover.

4. Move the cleaning brush along the separation
claw from left to right and remove any stains.

5. Close left cover.

KMIS Service Team, Kyocera Mita Europe 5425 / SB 2BJ-015