Mitac Digital Technology N372 User Manual
Magellan® eXplorist® Pro 10
MiTAC Digital Corporation 471 El Camino Real, Santa Clara, CA 95050 USA www.magellanGPS.com
Touch Pro 10 UM.indd 1 1/13/2011 2:08:02 PM
Quick Start Guide
Safety Notice
The Magellan eXplorist Pro 10 is a navigation aid designed to assist you in
arriving at your selected destination. When using the Magellan eXplorist receiver,
these safety rules must be followed to prevent accidents that can result in injury
or death to yourself or others.
Please do not try and change any settings on the Magellan eXplorist receiver
while driving. Come to a complete stop or ask a passenger to make any changes.
This product is an excellent navigation aid, but does not replace the need for
careful orienteering and good judgement. Never rely solely on one device for
navigating.
The Global Positioning System (GPS) is operated by the U.S. Government,
which is solely responsible for the accuracy and maintenance of the GPS
network. The accuracy of position xes can be affected by the periodic
adjustments to GPS satellites made by the U.S. government and is subject to
change in accordance with the Department of Defence civil GPS user policy and
the Federal Radionavigation Plan. Accuracy can also be affected by poor satellite
geometry and obstructions, like buildings and large trees.
Use only Magellan cables and accessories; the use of non-Magellan cables and
accessories may severely degrade performance or damage the receiver, and will
void the warranty.
The information provided in this document is subject to change without notice.
Improvements and enhancements to the product may occur without any formal
notication. Check the Magellan website (www.magellanGPS.com) for product
updates and additional information.
Maximum normal use temperature is 60°C.
Touch Pro 10 UM.indd 2 1/13/2011 2:08:02 PM
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for class B digital
devices, in accordance with part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC Caution: Any changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specic operating instructions for
satisfying RF exposure compliance.
Touch Pro 10 UM.indd 3 1/13/2011 2:08:02 PM
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
In order to maintain compliance with FCC regulations, shielded cables must be used
with this equipment. Operation with non-approved equipment or unshielded cables
is likely to result in interference to radio and TV reception. The user is cautioned
that changes and modications made to the equipment without the approval of
manufacturer could void the user’s authority to operate this equipment.
This Class B digital apparatus meets all requirements of the Canadian InterferenceCausing Equipment Regulations.IC statement
Operation is subject to the following two conditions:
1. This device may not cause interference and
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
IMPORTANT NOTE:
IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits established for an
uncontrolled environment. End users must follow the specic operating instructions for
satisfying RF exposure compliance.
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
Touch Pro 10 UM.indd 4 1/13/2011 2:08:02 PM
Loading...