A00811 MST ASPIRE DUST MOP TRMT 20N16
A00811 MST ASPIRE DUST MOP TRMT 20N16
Material number
1310 Seaboard Industrial Blvd., NW
Atlanta, GA 30318
Telephone
Emergency telephone numbers
Compliance Services 1-877-428-9937
877-541-2016 Toll Free - All Calls Recorded
For a Transportation
Emergency
CHEMTREC: 800-424-9300 - All Calls Recorded.
In the District of Columbia 202-483-7616
Aerosol containing a liquefied gas
H280 Contains gas under pressure; may explode if heated.
Storage:
P410 + P403 Protect from sunlight. Store in a well-ventilated
place.
P412 Do not expose to temperatures exceeding 50 °C/ 122 °F.
SECTION 1. PRODUCT AND COMPANY IDENTIFICATION
Manufacturer or supplier's details
Recommended use of the chemical and restrictions on use
SECTION 2. HAZARDS IDENTIFICATION
Emergency Overview
GHS Classification
GHS label elements
SECTION 3. COMPOSITION/INFORMATION ON INGREDIENTS
1 / 10
A00811 MST ASPIRE DUST MOP TRMT 20N16
Do not leave the victim unattended.
Show this safety data sheet to the doctor in attendance.
Move out of dangerous area.
If unconscious place in recovery position and seek medical
advice.
If symptoms persist, call a physician.
If skin irritation persists, call a physician.
Wash off immediately with plenty of water for at least 15
minutes.
If on clothes, remove clothes.
Remove contact lenses.
Protect unharmed eye.
Keep eye wide open while rinsing.
If eye irritation persists, consult a specialist.
Rinse immediately with plenty of water for at least 15 minutes.
Keep respiratory tract clear.
Never give anything by mouth to an unconscious person.
If symptoms persist, call a physician.
DO NOT induce vomiting unless directed to do so by a
physician or poison control center.
Take victim immediately to hospital.
Most important symptoms
and effects, both acute and
delayed
Effects may be delayed, symptoms may include minor eye or
skin irritation.
Overexposure may cause mild eye or skin irritation.
Treat symptomatically. Symptoms may be delayed.
Suitable extinguishing media
Dry chemical
Water spray jet
Alcohol-resistant foam
Carbon dioxide (CO2)
Unsuitable extinguishing
media
Specific hazards during
firefighting
Do not allow run-off from fire fighting to enter drains or water
courses.
Hazardous components
The exact percentages of disclosed substances are withheld as trade secrets.
SECTION 4. FIRST AID MEASURES
SECTION 5. FIREFIGHTING MEASURES
2 / 10
A00811 MST ASPIRE DUST MOP TRMT 20N16
Hazardous combustion
products
Carbon dioxide (CO2)
Carbon monoxide
Smoke
Specific extinguishing
methods
Standard procedure for chemical fires.
Use extinguishing measures that are appropriate to local
circumstances and the surrounding environment.
Special protective equipment
for firefighters
Wear self-contained breathing apparatus for firefighting if
necessary.
Personal precautions,
protective equipment and
emergency procedures
Use personal protective equipment.
Beware of vapours accumulating to form explosive
concentrations. Vapours can accumulate in low areas.
Environmental precautions
Prevent further leakage or spillage if safe to do so.
Prevent product from entering drains.
Prevent further leakage or spillage if safe to do so.
Methods and materials for
containment and cleaning up
Soak up with inert absorbent material (e.g. sand, silica gel,
acid binder, universal binder, sawdust).
Sweep up or vacuum up spillage and collect in suitable
container for disposal.
Avoid exposure - obtain special instructions before use.
Avoid contact with skin and eyes.
For personal protection see section 8.
Smoking, eating and drinking should be prohibited in the
application area.
Do not breathe vapours or spray mist.
Take precautionary measures against static discharges.
Provide sufficient air exchange and/or exhaust in work rooms.
Dispose of rinse water in accordance with local and national
regulations.
Always replace cap after use.
Conditions for safe storage
BEWARE: Aerosol is pressurized. Keep away from direct sun
exposure and temperatures over 50 °C. Do not open by force
or throw into fire even after use. Do not spray on flames or
red-hot objects.
Observe label precautions.
Keep in a dry, cool and well-ventilated place.
Electrical installations / working materials must comply with
the technological safety standards.
No smoking.
Materials to avoid
No materials to be especially mentioned.
SECTION 6. ACCIDENTAL RELEASE MEASURES
SECTION 7. HANDLING AND STORAGE
3 / 10