Mistana W005366172 Assembly and Installation Instructions

ASSEMBLY AND INSTALLATION
2. READ
AND
SAVE
THESE
INSTRUCTIONS.
Hardware
Package
(included):
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codeds for wiring and grounding requirements.
Mounting Screw (A) Wire Connector
(B)
Finial (G) Pure Shell(H) Fishing Line(I) Lock Nut (J)
Wire Connector (B)
Housing Wire
Outlet Box
Housing Grounding Wire
Fixture Grounding Wire
Anchor (D)
Mounting Plate
Fixture Mounting Screw (F)
Drywall screw (C)
Dry Wall Anchor(D) Green Grounding Fixture Mounting Screw (C) Screw (E) Screw (F)
Fixture Wire
Green Grounding Screw (E)
Bulb Type B Max. 40W(not included)
Lock Nut (J)
Finial (G)
Socket
Pure Shell (H)
Mounting Screw (A)
Fixture
Installation Steps
Turn off the power at fuse or circuit box
1.Cut the “H” plastic buckles with scissor when take down the PE bags. (See Fig.1)
2. Remove the mounting plate from fixture by unscrewing two Finials.
3.Fix the mounting plate to the a) For wooden material: Attach the mounting plate to the outlet box by using two mounting screws, and then secure the dry wall screws through the set holes to the wall. b) For cement material: Place the mounting plate to the outlet box and mark the target on the wall from the set hole for drilling two holes.
wall.
Remove
the mounting
plate
from
the outlet
box. Thread
the anchors
into the holes,
then
attach
the mounting
plate to the outlet box by using two mounting screws. Secure the dry wall screws through the set holes into
Shell(H)
A:
28"
B: 8-
7/8"
C: 5-
1/2"
the anchors.
4. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follow:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) f
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green grounding screw, and then connect it to the house grounding wire with the wire connector. Carefully put the wires back into the outlet box.
rom the fixture to the white wire from the power source.
5. Attach the back plate to the mounting plate by inserting fixture mounting screws with two finials.
6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.
into the holes, then secure it
Turn on the power at fuse or circuit box
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Wire Connector
Mounting Plate (A) Screw (C) Screw (E)
(B)
Dry Wall Anchor(D) Green Grounding
Assembly Kit
Fixture Mounting Finial Pure
Screw (F) (G)
Fishing Line(I) Lock Nut (J)
Loading...