Page 1
ASSEMBLY INSTRUCTIONS
Description : 24” MISSION PLANT STAND
Page 2
BEFORE ASSEM
B
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
PART
LIST
HARDWARE LIST
NO Description
Qty Sketch
NO
Description
Qty Sketch
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish of your
table. Protect the surface of the table with cloth if you are using any product with rubber feet or base.
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A TABLE TOP 1 B
SHELF
C
BOTTOM
1
SIDE
FRAME
2
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
1
(M6x35mm)
LOCK WASHER
(6.5x11mm)
3
BOLT
8
8
FLAT WASHER
(6.5x16mm)
2
ALLEN KEY
4
(4X80mm)
8
1
Page 3
STEP
1
Attach side frames (B) to top (A) with bolts (1), and washer (2), and (3) as shown below. Tighten with
Allen key (4).
STEP 2
Attach shelf bottom (C) to side frames (B) with bolts (1), and washer (2), and (3) as shown below.
Tighten with Allen key (4).
Loading...