ASSEMBLY AND INSTALLATION
2.
READ
AND
SAVE
THESE
INSTRUCTIONS.
Hardware
Package
(included):
Turn
off the power
at
fuse or circuit
box
1.Cut
the “H” plastic
buckles
with scissor
when
take down
the PE bags.
(See
Fig.1)
2. Remove
the mounting
plate
from fixture
by
unscrewing
four Finials.
3.Fix
the mounting
plate
to
the wall.
a)
For wooden
material:
Attach
the mounting
plate
to
the outlet
box by using
two
mounting
screws,
and then secure
the dry wall screws
through
the set holes
to
the wall.
INSTRUCTIONS
NOTES:1. Before installing, consult local electrical codeds for wiring and grounding requirements.
Mounting Screw (A) Wire Connector
(B)
Finial (G) Pure Shell(H) Fishing Line(I) Lock Nut (J)
Wire Connector (B)
Housing Wire
Housing Grounding Wire
Fixture Grounding Wire
Outlet Box
Anchor (D)
Mounting Plate
Dry Wall Anchor(D) Green Grounding Fixture Mounting
Screw (C) Screw (E) Screw (F)
Fixture Wire
Green Grounding Screw (E)
Mounting Screw (A)
Bulb Type B Max.
40W(not included)
Lock Nut (J)
Finial (G)
Socket
Fixture Mounting Screw (F)
Drywall Screw (C)
Fixture
Installation Steps
Pure Shell (H)
b) For cement material:
Spare
Parts
List:
A:42"
B:8-7/8"
C:5-1/2"
Place the mounting plate to the outlet box and mark the target on the wall from the set hole for drilling two holes.
Remove the mounting plate from the outlet box. Thread the anchors into the holes, then attach the mounting plate
to the outlet box by using two mounting screws. Secure the dry wall screws through the set holes into the anchors.
4. Pull out the source wires from the outlet
box. Make wire connections using wire connectors as follow:
---Connect the hot wire (usually black insulation) from the fixture to the
black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the
white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green
grounding
screw, and then connect it to the house grounding wire with the wire connector.
Carefully put the wires back into the outlet box.
5. Attach the back plate to the mounting plate by inserting fixture mounting screws into the holes, then secure it with two
finials.
6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.
Turn on the power at fuse or circuit box
The following parts are available for re-order if damaged or missing.
Mounting Plate(A)
Fixture Mounting Fi nial (G) Pure Shell(H) Fishing Line(I) Lock Nut (J)
Screw (F)
Wire Connector
(B)
Dry Wall Anchor(D) Green Grounding
Screw (C) Screw (E)
Assembly Kit
Loading...