ASSEMBLY INSTRUCTIONS
END TABLE
- 1 -
IMPORTANT NOTE:
BEFORE ASSEMBLY
NOT INCLUDED
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
ASSEMBLY TOOLS REQUIRED
- 2 -
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
HARDWARE
LIST
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
Table top 1
A
Side frame
C
E
G
I
(L-R)
Drawer
front panel
Drawer
side panel
(L-R)
Back
crossbar
B
2
1
2
1
D
F
H
Back panel 1
Bottom shelf 1
Drawer back
panel
Drawer bottom
panel
1
1
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following parts:
NO Description Qty Sketch NO Description Qty Sketch
1
3
5
7
Short bolt
(M6x35mm)
Flat washer
(6.5x19mm)
Short screw
(M4x15mm)
Knob
(38x30mm)
8
8
14
1
- 3 -
2
4
6
(M4x30mm)
8
Spring washer
(6.5x11mm)
Screw
(M4x30mm)
Pan head
screw
Allen key
(4mm)
8
8
1
1
STEP 1
Attach side frames (C) to top (A) with bolts (1), and washers (2) and (3) as shown below. Tighten with
Allen key (8).
- 4 -
STEP 2
Attach side frames (C) to top (A) and bottom shelf (D) with bolts (1), and washers (2) and (3) as
shown below. Tighten with Allen key (8).
Attach side frames (C) to back crossbar (I) as shown below.
- 5 -
STEP 3
Attach back panel (B) to the unit with screws (5) as shown below. Tighten with a screwdriver.
STEP 4
Attach panels (H), (E), (F) and (G) together with screws (4) as shown below. Tighten with a
screwdriver.
Attach knob (7) to drawer front (E) with screw (6). Tighten with a screwdriver.
- 6 -
STEP 5
Insert drawer into the unit as shown below.
- 7 -
Loading...