Page 1
ASSEMBLY AND INSTALLATION
2.
READ
AND
SAVE
THESE
INSTRUCTIONS.
Hardware
Package
(included):
Grounding
Installation
Steps
take
down
the PE bags.
(See
Fig.1)
to
the outlet
box by using
two mounting
screws.Secure
the two dry wall screws
through
the set holes
into the anchors.
3.Connect
the chain:
- Determine
length
of
chain
needed
to
achieve
desired
fixture
height.
(To remove
excess
chain
section,
use pliers
to
bend
link open.)
- Weave
the fixture
wires
through
the chain,
top loop
and canopy.
4.Connect
both
ends
of
the chain
to
the loop
using
a
loop
lock.
5.Thread
the fixture
wire and fixture
grounding
wire through
the top loop,
canopy
and
mounting
plate.
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codeds for wiring and grounding requirements.
Mouting Plate Drywall Screw Green
(A) (B) Screw (C)
Loop Lock (H) Chain (I) Pure Shell(J) Fishing Line(K)
Turn off the power at fuse or circuit box
1.Cut the “H” plastic buckles with scissor when
Wire Connector
Mounting Screw (E)
(D)
Housing Grounding Wire
Fixture Grounding Wire
Finial (G)
Chain (I)
Anchor (F)
Mouting Plate (A)
2. Set holes on the wall surface for drilling.
Remove the Mounting Plate from the
Canopy by removing two finials. Drill
two set holes.Thread the anchors into
the holes, then attach the Mounting Plate
Anchor (F)
Finial (G)
Outlet Box
Housing Wire
Wire Connector (D)
Fixture Wire
Socket
Pure Shell (J)
Bulb Type A Max.60W (not included)
Page 2
6.Pull out the source wires from the outlet box.
Grounding
Make wire connections using wire connectors as follows:
---Connect the hot wire (usually black insulation) from the power source to the smooth-coated wire(marked)
from the fixture.
---Connect the neutral wire (usually white insulation) from the power source to the ribbed-coated
wire(unmarked) from the fixture.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green
grounding screw, or connect to the sourc
e grounding wire if available.
Carefully put the wires back into the outlet box.
7.Attach the canopy to the mounting plate and secure it with two finials.
8. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.
Turn on the power at fuse or circuit box
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Drywall Screw Green
(B) Screw (C)
Anchor (F) Finial (G)
Pure Shell(J) Fishing Line(K)
Wire Connector
Loop Lock (H)
Mounting Screw (E)
(D)
Assembly Kit
Chain (I)
CA
B
A: 36"
B: 18.25"
C: 15"
Loading...