Page 1
ITEM
NO.: S-202
Printed in Vietnam
ASSEMBLY INSTRUCTIONS
REVISED NOV 14, 2012
- 1 -
Description
Item No.
: 24 IN DOUBLE XX BACK STOOL
: S-202
Page 2
ITEM
NO.: S-202
Printed in Vietnam
BEFORE ASSEM
BLY
PART
LIST
NOT INCLUDED
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
ASSEMBLY TOOLS REQUIRED
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
Front Leg
A Chair back 1
C Seat Frame 1
B
Front Stretcher
D
(L-R)
2
1
E
Short side
stretcher -
Upper
2
F
Long side
stretcher -
Lower
2
G Chair Seat 1
REVISED NOV 14, 2012
- 2 -
Page 3
ITEM
NO.: S-202
Printed in Vietnam
HARDWARE LIST
STEP 1
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1
(M6x40mm)
3
(M6x80mm)
Lock Washer
5
(ɸ6.5x13mm)
7
Short bolt
Long bolt
Allen Key
(4mm)
3
4
11
1
Medium bolt
2
4
6
(M6x60mm)
Flat Washer
(ɸ6.5x19mm)
Screw
(M4x35mm)
4
11
14
Attach Seat Frame (C) to the Back (A) by using bolts (1) and (3), Washers (4) and (5). Tighten with the
Allen Key (7) as shown below.
Note: DO NOT fully tighten any of the bolts, until the chair is assembled, then put on a flat level
surface to make sure the chair is level and then tighten the bolts.
REVISED NOV 14, 2012
- 3 -
Page 4
ITEM
NO.: S-202
Printed in Vietnam
STEP 2
STEP 3
Attach Front Legs (B) to the seat frame (C) with bolts (2), Washers (4) and (5). Tighten with Allen Key
(7).
Place Side Stretchers (F) and (E) between front and back legs, and place the Front Stretcher (D)
between front legs, use the screwdriver to tighten the screws (6) as shown below.
Attach Chair Seat (G) to top of the Seat Frame (from Step 2) with Screws (6). Tighten with a screw
driver.
REVISED NOV 14, 2012
- 4 -
Loading...