Page 1
ASSEMBLY INSTRUCTIONS
Page 2
BEFORE ASSEM
B
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
PART
LIST
NO Description
Qty Sketch
NO
Description
Qty Sketch
NOT INCLUDED
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
ASSEMBLY TOOLS REQUIRED
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
Chair
A
back
C Chair Seat 1 D
Side
E
Stretcher
(L-R)
1 B
2
Seat
Frame
Front Leg
(L-R)
1
2
Page 3
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
NO Description
Qty Sketch
NO
Description
Qty Sketch
STEP 1
please make sure you have all of the following hardware:
1
3
5
(6.5 x11mm)
7
Short bolt
( M6 x 40mm)
Long bolt
(M6 x 80mm)
Lock Washer
Allen Key
(4x80mm)
3 2
4 4
11 6
1
Medium bolt
4
(M6 x 60mm)
Wood Screw
8
(M4 x 35mm)
Flat Washer
11
(6.5 x19mm)
Attach seat frame (B) to the back (A) by using bolts (3) and (1), and washers (5) and (6). Tighten with
allen key (7) as shown below.
Note: DO NOT tighten any of the bolts, until the chair is assembled, then put on a flat level surface to
make sure the chair is level and then tighten the bolts.
Page 4
Attach front legs (D) to the seat frame (B) with bolts (2), and washers (5) and (6).Tighten with allen key
STEP 2
STEP 3
(7).
Place side stretchers (E) between front and back legs. Attach stretchers with the screws (4) as shown
below. Tighten with a screwdriver.
Attach the seat (C) to top of the seat frame by using screws (4) as shown below. Tighten with a
screwdriver.
Loading...