Mirror Image Teleprompters SF-160 User Manual

SF Studio Series

Set-Up Instructions

Teleprompter Parts

Step #1

Remove the quick-release plate from your tripod head. Set the plate on a flat surface (table,
desk, etc) with anti-skid pads on top & camera bolts pointing up. Set Mirror Image mount arm
on top of the plate so that the camera bolts go thru the long slot in mount arm. Place Mirror
Image T-Nut into the long slot so that it sits over the top of the camera bolts (longer, flat surface
of the T-Nut should be on top so that the protruding surface fits into the slot on the mount arm).
Thread the camera bolts into the tapped holes in the t-nut (sandwiching the mount arm between
the t-nut & quick-release plate). Before tightening the bolts completely, position the t-nut &
plate assembly near the front of mount arm (between the 4 bolts & knobs). Tighten securely and
place assembly back on tripod.