Mira 1731.002, 1731.001 User Manual
MIRA PREMIUM SHOWER SEAT
1731.001 & 1731.002
Installation & User Guide
These instructions must be left with the user
1
2
INTRODUCTION
Important Points
The Mira shower seat has been designed for installation inside a shower cubicle,
over a bath or within the drying area.
The shower seat must be secured to a at, sound and solid wall surface (‘solid’
means constructed of brick or high density concrete block).
Warning! All screws and wall plugs supplied must be securely tted to the full
depth.
Warning! This product has been designed as a seat only and should not be used
for any other purposes.
Note! The shower seat may be xed to other wall types, but advice must be sought
from a competent builder regarding wall structure and fastening prior to tting.
Cavities, voids, loose material, cables and pipes must be avoided when locating
the xing screws.
Maximum Weight - 150 kg (23 stone) evenly distributed about the seat.
Fixing Height
The xing height of the shower seat depends largely on the height of the user, it
will usually be somewhere between 400-500 mm above the bottom of the shower
tray, bath or oor.
A simple method of determining the shower seat height would be to measure the
seat height of the users favourite/most comfortable chair, and x the shower seat
at a similar height.
3
PACK CONTENTS
Tick the appropriate boxes to familiarise yourself with the part names and to conrm
that all of the parts are included.
1 x Shower Seat
1 x Wallplate
DIMENSIONS
4 x Wall Plugs
4 x Fixing Screws
1 x Hexagonal Key
365 mm
350 mm
440 mm
48 mm
Loading...