Page 1
A
r
A
j
A
f
y
A
f
r
f
SSL-DOOR User’s Manual
IMPORTANT: Read all of the instructions before
attempting to install the SSL-DOOR sensor.
DESCRIPTION
The SSL-DOOR sensor is a device, which connects to the
SSL-EMD. When a door/window is opened the magnetic
field is broken. Through the SNMP-SSL card, the user can
monitor it and receive notifications of the alarms.
APPLICATION
SSL-DOOR sensors are commonly used in burglar alarm
systems as door/window open sensors; however they can
be disabled if they are in a strong, external magnetic field.
If a security sensor is dropped onto a hard surface from
more than 30cm or subject to shock of more than 30G, it is
possible to cause the characteristics to change (Pull-in,
Drop-out, etc.).
INSTALLATION
1. Loosen the screws on SSL-EMD.
2. Connect the wires of SSL-DOOR to the SSL-EMD
larm-1 and/or Alarm-2, and then tighten the screws.
3. Attach the sensors to the door and doorframe.
4. Connect the straight-through CAT5 network cable from the
SNMP-SSL card’s RJ45 connector labeled “COM” to the
connector labeled “010101” on the SSL-EMD.
5. Verify that the SNMP-SSL card has a network connection
and is powered on.
6. Check the LED (Power/Status) of SSL-EMD, it will flash
every 5-seconds.
7. Open a Web browser and connect to the SNMP-SSL card.
8. Change the setting of “SSL-EMD Status” from “Disable” to
“Auto” on the EMD Configuration page.
9. Set the status of Alarm-1 and/or Alarm-2 to “Normal
Open”.
10. The installation of the SSL-DOOR is complete. See the
SNMP-SSL User’s Manual.
LIMITED PRODUCT WARRANTY
Para Systems Inc. (Para Systems) warrants this equipment, when
properly applied and operated within specified conditions, against
faulty materials or workmanship for a period of three years from the
date of original purchase by the end user. For equipment sites within
the United States and Canada, this warranty covers repair o
replacement of defective equipment at the discretion of Para
Systems. Repair will be from the nearest authorized service center.
Replacement parts and warranty labor will be borne by Para Systems.
For equipment located outside of the United States and Canada, Para
Systems only covers faulty parts. Para Systems products repaired
or replaced pursuant to this warranty shall be warranted for the
remaining portion of the warranty that applies to the original product.
This warranty applies only to the original purchaser who must have
properly registered the product within 10 days of purchase.
The warranty shall be void if (a) the equipment is damaged by the
customer, is improperly used, is subjected to an adverse operating
environment, or is operated outside the limits of its electrical
specifications; (b) the equipment is repaired or modified by anyone
other than Para Systems or Para Systems-approved personnel; or (c)
has been used in a manner contrary to the product's operating
manual or other written instructions.
ny technical advice furnished before or after delivery in regard to use
or application of Para Systems’s equipment is furnished without
charge and on the basis that it represents Para Systems’s best
udgment under the circumstances, but it is used at the recipient's
sole risk.
EXCEPT AS PROVIDED HEREIN, PARA SYSTEMS MAKES NO
WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
PARTICULAR PURPOSE. Some states do not permit limitation o
implied warranties; therefore, the aforesaid limitation(s) may not appl
to the purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL PAR
SYSTEMS BE LIABLE FOR DIRECT, INDIRECT, SPECIAL,
INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT OF
THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE
POSSIBILITY OF SUCH DAMAGE. Specifically, Para Systems is
not liable for any costs, such as lost profits or revenue, loss o
equipment, loss of use of equipment, loss of software, loss of data,
cost of substitutes, claims by third parties, or otherwise. The sole
and exclusive remedy for breach of any warranty, expressed o
implied, concerning Para Systems’s products and the only obligation
of Para Systems hereunder, shall be the repair or replacement o
defective equipment, components, or parts; or, at Para Systems’s
option, refund of the purchase price or substitution with an equivalent
replacement product. This warranty gives you specific legal rights
and you may also have other rights, which vary from state to state.
OBTAINING TECHNICAL ASSISTANCE
Para Systems (Minuteman UPS) Technical Support:
Phone: 1-972-446-7363
Fax: 1-972-446-9011
Web: www.minutemanups.com/support/con_tech2.php
www.minutemanups.com © Copyright 2008 34000365 R1
Loading...