Minolta Di 152, Di 183 Disassembly Printer Registration
FrameMaker Ver.5.5E(PC) DIS/REASSEMBLY, ADJUSTMENT FOR Di152/Di183
01.09.03
(3) Printer CD Registration Adjustment
Requirement
• Adjust so that width A on the test print produced
falls within the specified range.
A
4686D504AA
Specifications Mode Code No. Setting Range
A4C: 20 ± 2.0 mm;
8-1/2 × 11C: 11.2 ± 2.0 mm
NOTES
• This adjustment is made when the PH Unit has been replaced.
• Load the 1st Tray with A4C or 8-1/2 × 11C paper.
<Adjustment Procedure>
1. Enter the Adjust mode.
2. With “AJ-” shown on the Display, enter the code number “12” from the 10-Key Pad.
3. Press the Paper key to select the 1st Tray.
4. Press the Start key.
✽
Then, a test print will be produced.
5. Check to see if width A on the test print falls within the specified range.
If width A falls outside the specified range, perform the following steps to make an
adjustment.
6. With “AJ-” shown on the Display, enter the code number “1” from the 10-Key Pad and
press the Start key to enter the “Printer CD Registration Adjustment” mode.
7. Press the Clear key to clear the current setting value.
8. Enter the new setting value from the 10-Key Pad and press the Start key to validate the
entry.
Adjust 1
60 to 140,
1 step: 0.1 mm
Adjustment Instructions
If width A on the test print is longer than the specifications, increase the setting value.
If width A on the test print is shorter than the specifications, decrease the setting value.
If a single adjustment procedure does not successfully bring width A into the specified
range, repeat steps 5 though 7.
D-55
FrameMaker Ver.5.5E(PC) DIS/REASSEMBLY, ADJUSTMENT FOR Di152/Di183
01.09.03
(4) Printer FD Registration Adjustment
Requirement
• Adjust so that width B on the test print produced
falls within the specified range.
B
4022D502AA
Specifications Mode Code No. Setting Range
10 ± 1.5 mm Adjust 2
NOTES
• This adjustment is made when the PH Unit has been replaced.
• Load the 1st Tray with A4C or 8-1/2 × 11C paper.
<Adjustment Procedure>
1. Enter the Adjust mode.
2. With “AJ-” shown on the Display, enter the code number “12” from the 10-Key Pad.
3. Press the Paper key to select the 1st Tray.
4. Press the Start key.
✽
Then, a test print will be produced.
5. Check to see if width B on the test print falls within the specified range.
If width B falls outside the specified range, perform the following steps to make an
adjustment.
6. With “AJ-” shown on the Display, enter the code number “2” from the 10-Key Pad and
press the Start key to enter the “Printer FD Registration Adjustment” mode.
7. Press the Clear key to clear the current setting value.
8. Enter the new setting value from the 10-Key Pad and press the Start key to validate the
entry.
67 to 133, 1 step:
Approx. 0.19 mm
Adjustment Instructions
If width B on the test print is longer than the specifications, decrease the setting value.
If width B on the test print is shorter than the specifications, increase the setting value.
If a single adjustment procedure does not successfully bring width B into the specified
range, repeat steps 5 though 7.
D-56
Loading...