Minleon 20080125 User Manual

REMOTE CONTROL INSTRUCTIONS:

Tech Spec:

1. Model Name: ZY16-12

2. Operating voltage: DC12V (12V/23A battery, shown as picture above)

3. Operating frequency: 433.92MHz

4. Frequency deviation: ± 0.2MHz

How to use:

1. The 1-12 buttons are all for the on/off power switch for the lights, one channel is for one light, total could
control 12 lights on/off. Press button 1 one time, the light on, press button 1 again, the light off.

2. Press one button, the remote control will transmitter a rf signal.

3. The remote control could not work in a sealed metal box.

4. When there is strong interference, you could pull straight the antenna of the remote control to reach
better function.

1 / 2

If the remote control does not work, check whether the battery of the remote control is
out of power.

To replace the remote control battery:

1. Open the back cover of the remote control.

2. Replace with a new alkaline “12V 23A” (12 volt) battery (included) into the compartment.

WARNING:

A. This is not a toy and is not intended for use by children.
B. Do not dispose of the battery in fire as the battery may leak and explode.
C.

Do not mix old and new batteries and do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries.

D. Exhausted batteries are to be removed from the product.
E. Use type “12V 23A” (12 volt) batteries.
F. Safe for indoor use.

G.

For this device, A transmitter activated automatically shall ceas e transmission within 5 se conds after
activation.

FCC warning:

Caution: Any changes or modifi ca tio ns to this device not explicitly ap pro ve d by manufacturer could void
your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

2 / 2