Mini Tec Megabite Limited Slip Differential User Manual

Megabite LSD

Installation Guide Part #230512

Applications:

- 1983-2001 Acura Integra (Exc. 1994-1999 GS-R)

- 1984-2001 Honda Civic SI/CRX

- 1993-1997 Honda Del Sol

Thank you for choosing Mini Tec.

Mini Tec recommends a certified technician install this system. In addition to these instructions,
professional knowledge of disassemble/reassembly procedures as well as post installation checks must
be known. Attempts to install this system without this knowledge and expertise may jeopardize the
integrity and/or operating safety of the vehicle.
Please read instructions before beginning installation.

Product Use Information

Mini Tec will not be responsible for any product that is altered.
If question exist we will be happy to answer any questions concerning the design, function, and correct
use of our products.

Kit Contains 1 Megabite Limited Slip Differential Unit (as seen in above photo)

Tools Needed

 Flathead screwdriver
 Dowel driver set
 And hammery hammer

Installation Instructions

1) Remove differential from transmission and place on workbench.

2) Remove small dowel pin out of spider gear centering shaft and slide out shaft.

3) For best results, remove the two spider gears and machine the excess material for a flat surface. Be sure to not
remove more than the raised section of the spider gear. By removing this excess material, the LSD will have more
surface area for higher friction.

4) Reinstall spider gears