Mincey Marble Manufacturing SS-02 Installation Instructions Manual

4321 Browns Bridge Road
Gainesville, GA 30504
Ph: 800.533.1806
Fx: 770.531.0935

www.minceymarble.com

Installation Instructions for Mincey Marble Manufacturing’s

Corner Mount Shampoo Shelf

Product number: SS-02

Please read the following before attempting to install your cast marble

corner mount shampoo shelf

These instructions have been written for Mincey Marble’s SS-02 cast marble

corner mount shampoo shelf. If you have a different product than shown, please

call us for instructions for the product you have purchased.

Mincey Marble Mfg., Inc.

SS-02

In preparation, before installing this shampoo shelf, you will need to have completed the
installation of the panel system and sealed the seams of the shower behind where the
shelf is to be installed with 100% silicone.

1

Materials/Tools required:

1. Torpedo level

2. Pencil

3. Silicone (100%) and caulk gun

4. Hot melt glue and hot melt glue gun

5. Clean, dry rags

6. Acetone*

Two types of adhesive are needed to install the shampoo shelf because they
serve different purposes. The hot melt glue bonds immediately, but will not hold
the shelf for more than a few days. The silicone takes a few hours to cure, but
after curing, it and the hot melt glue together will secure the shampoo shelf
indefinitely.

 *Please use acetone only. Denatured alcohol or other water-based cleaners

are not acceptable. If you do not have acetone, wiping with a clean, dry rag
is an acceptable alternative.

NOTE: The shampoo shelf should be located on the wet wall or in the corner of

the shower, adjacent to the showerhead and strategically located 48” above the
shower floor.

IMPORTANT NOTE: The supports are molded with a built in 1/8” downdraft

towards the front (open side) of the shelf, for drainage. (see illustration below)

2