Milwaukee pH600 Instruction Manual

Instruction Manual

 pH600
pH Tester

www.milwaukeetesters.com

 Do not be
alarmed if
white crystal
appear around
the cap. This is
normal with pH
electrodes and they dissolve
when rinsed with water.

OPERATING:

 Remove the protective cap
and turn the pH600 on.
Immerse it into solution up to
the maximum immersion
level.
 Stir gently and wait until
the display stabilizes.
After use, rinse the electrode
with water to minimize
contamination.
 Store the electrode with a
few drops of storage solution
(MA9015) or pH 7.01 buffer
solution in the protective
cap.
 Always replace the
protective cap after use.

DO NOT USE DISTILLED
OR DEIONIZED WATER
FOR STORAGE
PURPOSES

 Large differences in pH
readings (± 0.5 pH) could be
due to lack of calibration, dry
electrode or rundown
batteries.

The calibration procedure is
very simple and fast.

CALIBRATION:



Immerse the tester
up to the maximum
level in pH 7 buffer
(M10007).



Allow the reading to
stabilize and using a
small screwdriver turn the
pH 7 Calibration Trimmer
placed on the back of the
tester to read 7.0.

Calibration is now complete!

ALWAYS USE FRESH
BUFFERS FOR
CALIBRATION

When the pH600
cannot be switched on
or the display fades,
pull out the battery
compartment and
replace all three 1,5V
batteries, paying attention to
their polarity.

BATTERY
REPLACEMENT:

Batteries should only be
replaced in a non-hazardous
area using the battery types

specified in this instruction
manual.

Before using this product, make sure that it is
entirely suitbale for the environment in which
it is used. Operation of this instrument in
residential area could cause unacceptable
interferences to radio and TV equipments,
requiring the operator to take all necessary
steps to correct interferences.

RECOMMENDATIONS
FOR USERS:

The glass bub at the end of the pH electrode
is sensitive to electrostatic discharge. Avoid
touching this glass bulb at all times. During
operation of instrument, ESD wrist straps
should be worn to avoid possible damage to
the pH by electrostatic discharge. Any
variation introduced by the user to the
supplied equipment may degrade the
istruments EMC performance. To avoid
electrical shock, do not use this instrument
when voltages at the measurement surface
exceed 24 VAC or 60 VDC. To av oid
damages or burns, do not perform any
measurement in microwave ovens.

SPECIFICATIONS:

RANGE 0.0 to 14.0 pH
RESOLUTION 0.1 pH

TYPICAL EMC ±0.2 pH

ACCURACY (@20°C) ±0.1 pH

ENVIRONMENT 0 to 50°C

DEVIATION

BATTERIES LIFE 3 x 1,5V

alkaline
approax. up to
700 hours of

95% RH

use
DIMENSIONS 150x30x24 mm
WEIGHT 85g

Alsókikötö sor 11.

H-6726 Szeged - HUNGARY

Tel: [phone]

Fax: [phone]

[e-mail]