Milwaukee M18, M12-18 JSSP, M12 Operator's Manual

Cat. No.
M12-18 JSSP
M18/ M12™ WIRELESS JOBSITE SPEAKER
OPERATOR'S MANUAL
To reduce the risk of injury, user must read and understand operator's manual.
WARNING
IMPORTANT SAFETY INSTRUCTIONS
WARNING
Read, understand and follow all instructions. Failure to heed all
warnings listed below, may result in electric shock,
Keep these in-
structions.
Read these instructions.
Keeps these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water. Never immerse
apparatus. Water entering an apparatus will increase the risk for electric shock.
Clean only with dry cloth. Certain cleaning agents
and solvents are harmful to plastics and other insulated parts. Some of these include: gasoline, turpentine, lacquer thinner, paint thinner, chlorinated cleaning sol­vents, ammonia and household detergents containing ammonia. Clean dust and debris from vents. Keep the apparatus handle clean, dry and free of oil or grease.
Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
Do not use near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
manufacturer.
Only operate this apparatus in a well ventilated area.
Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture or does not operate normally. Service or maintenance performed by unquali-
A battery operated apparatus with integral batter­ies or a separate battery pack must be recharged
A
charger that may be suitable for one type of battery
­cally designated battery packs. Use of any other bat-
When battery pack is not in use, keep it away from other metal objects like: paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another.
Shorting the battery terminals together may cause
Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators. There
is an increased risk of electric shock if your body is grounded.
Never disassemble the apparatus or try to do any rewiring on the apparatus's electrical system.
Do not expose this apparatus to dripping and splash-
SPECIFIC SAFETY RULES
Federal Communications Commission
WARNING: Changes or modifications to this unit
not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV techni-
cian for help.
SYMBOLOGY
Volts
Direct Current
Double Insulated
Amps
To reduce the risk of injury, user must
read operator's manual.
Indoor Use Only
Regulatory Compliance mark (RCM). This product meets applicable regulatory requirements.
Similarly in Australia and New Zealand this product complies to ACMA EMC requirements.
V
Maintain labels and nameplates. These carry important information. If unreadable or missing, contact a MILWAUKEE® service facility for a replacement.
This apparatus is designed to be powered by either an 18 volt or a 12 volt MILWAUKEE
®
Li-ion battery pack. Do not attempt to use with
any other voltage or power supply.
Use only System M12/ M18 chargers for charging System M12/ M18 battery packs. Do not use battery/ packs from other systems.
Temperatures in excess of 50°C (122°F) reduce the performance of the battery pack. Avoid extended exposure to heat or sunshine (risk of overheating).
Loading...
+ 2 hidden pages