PRODUCT GUIDE & ASSEMBLY INSTRUCTIONS
Track Arm Sofa
Guidelines
FAILURE TO FOLLOW THESE WARNINGS
WHEN IN USE COULD RESULT IN INJURY
• Do not stand on the item or use as a step ladder
• Do not use this item unless all bolts and screws are
firmly secured and fastened.
• Check all bolts and screws every 90 days. As
necessary tighten if any are loose.
• Lift up then move. Pushing over or dragging this
product can result in an injury or cause damage to
the floor and piece.
33
WARNING:
DO NOT LET CHILDREN PLAY IN OR AROUND
THE UNIT DUE TO THE POSSIBLE RISK OF INJURY.
Pre-Assembly Preparation:
Please read through this instruction booklet before
beginning assembly of this item.
Two adults are recommended for assembly.
• Clear out the space for assembly and lay out all
parts on Parts List, extra room will allow you to
easily determine if all the pieces are present.
• Save all packing materials until assembly is
complete to avoid accidentally discarding smaller
parts or hardware.
• Keep small parts and pieces away from children
and pets until fully assembled.
• Please check for any loose screws and tighten them
before you use.
4
Parts List
1
Arm and Seat Frame
with “L” Label (1)
4
Back Frame with
“R” Label (1)
Back Cushions
7 8
(Left & Right) (2)
Arm and Seat Frame
2 3
with “R” Label (1)
5 6
Seat Cushions
(Left & Right) (2)
Back Covers
(Left & Right) (2)
Back Frame with
“L” Label (1)
Seat Covers
(Left & Right) (2)
5
Parts List
Thumb Bolts (5)
5/16*60mm
D E
Flat Washers (4) T-Nuts (2)
B C
Side Legs (4)
MIddle Legs (2)A
6
Step 1
Remove all parts from the carton and place them on a protected
surface or carpet. Place the Arm and Seat Frames (1 & 2) upside
down and open the bottom flap. Take the Back Cushions (7), Side
Legs (B), Middle Legs (C), Flat Washers (D), T-Nuts (E), Back Frames
(3 & 4) and Thumb Bolts (A) out of the seat box.
7
Step 2
Turn over the Arm and Seat Frame with “R” Label (2) and slide
the Back Frame with “R” Label (4) into the seat frame until fully
engaged. Align the holes of the Back Frame (4) to the Arm
Frame (2) and secure with one Thumb Bolt (A).
8
Step 3
Turn over the Arm and Seat Frame with “L” Label (1) and slide
the Back Frame with “L” Label (3) into the seat frame until fully
engaged. Align the holes of the Back Frame (3) to the Arm
Frame (1) and secure with one Thumb Bolt (A).
9
Step 4
Move the two assembled parts together. Align the holes of
Seat Frames (1 & 2) and Back Frames (3 & 4) to the other side
and secure with one Thumb Bolt (A) to the back frames.
Thumb Bolts (A), Flat Washers (D) and T-Nuts (E). Ensure all
Thumb Bolts (A) are completely tightened.
10
Step 5
Secure the bottom and back flaps with hook and loop tape.
Remove the plastic caps on the threaded bolts of each leg.
Attach the Side Legs (B) to the corners of the sofa. Then screw the
middle legs（C）in the frame as the sketch shown.
11
Step 6
Open the vacuum packed Seat Cushions (5) by carefully cutting
the bags with a pair of scissors. Insert the Back Cushions (7) into
the appropriate Back Covers (8). Insert the Seat Cushions (5) into
the appropriate Seat Covers (6). Remember to keep the top side
of the Seat Cushions (5) with the top side of the Seat Covers (6).
Fluff all cushions to allow them to expand. Lastly, position all
cushions on the sofa. Seat and back cushions may take 24-48
hours to fully expand, which will allow wrinkles and indentations
caused by packing to fade. Note: There is a hook and loop strip
between the back cushions and the back frame. Please stick
them according to the location.
12
ATTENTION: To close the zipper, please follow Diagram 1.
Failure to follow this could result in damage to the zipper.
Limited Warranty
The manufacturers products are warrantied against defects in material and workmanship
while owned by the “Original Purchaser”. The term “Original Purchaser” is defined as the
party or entity which purchases this manufacturer’s furniture from an authorized retailer
as shown by the original sales receipt. This warranty does not apply to “as is” or
previously owned products.
The manufacturer warrants its products to be free from defects in materials and
workmanship (normal wear and tear, fading and stretching excepted), for one year
from the date of purchase, except as provided below under the limited warranty.
The exceptions or exclusions to this warranty are as follows:
at is submitted after the limited warranty period, or without
1. Any warranty claim
proper proof of purchase will not include the cost of par ts, labor, or delivery.
2. This warranty shall not apply to the manufacturer’s products which have been
subjected to misuse, neglect, alteration, modification, or attachments, either caused by
the Original Purchaser, shipping, storage, accident, fire, flood, or acts of God.
In the event of a defect in material or workmanship covered by this warranty, the
manufacturer will repair or replace, at their discretion, without charge the warrantied
parts within a reasonable amount of time. We reserve the right to require damaged parts
be returned to us upon request. Natural markings such as scars, brands, grain variations,
wrinkles, color variations, etc. will be considered normal characteristics and not
construed as defects.
th
13
Loading...