Millwood Pines FOME6775 Assembly Instructions

CAUTION : You must read this before you proceed

This Table is NOT a TOY

Keep your child/ children at bay during the assembly process.

Page 1 of 7

TABLE

CAUTION:

For moving the Table and to prevent damage to the Table, two adults are
needed to execute this action.

Label Picture Description QTY

①

③

Table Top

A

1

legs）

B Support Bar 1

Label Picture Description QTY

（with folding

②

Bolt

(M8x20mm)

Washer

(M8.5×20x2mm)

Allen Key

11

11

1

Page 2 of 7

Before Beginning Assembly:

Page 3 of 7

Table
Top (A)

Support Bar (B)

FRONT

FACING

This Table has multiple parts and may require up to some 15 minutes to
assemble. To give you an overview of the Table parts, the above picture is to
help you put the various parts into perspective. Please read through the
instructions below to familiarise yourself with the parts and steps before
assembly.

Step 1

Unpack and place all parts on a clean non -marring surface.

Page 4 of 7

Step 2

) and Allen

Scratches or clamages to the product Lift legs upwards and outwards until the
braces are met at position to the table ,as shown in the above picture

DO NOT FULLY TIGHTEN THE BOLTS.

A

Page 5 of 7

3

1

1

A

2

2

Place the Table (A) facedown, on to a clean, soft surface to avoid any

Secure Legs to Table by using Bolts (①) and Washers (②) with Allen Key
(③), Total 8 posittions.

Step 3

B

3

1

2

Attach the Support Bar (B) to the Legs as shown in picture above.
Affix the Support bar (B) with the Legs by using bolts (①), washer (②
key (③), Total 2 posittions.

DO NOT FULLY TIGHTEN THE BOLTS.

Step 4

Turn the Table right side up.
Place the Table on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and gracefully, place a force onto the table top.
This would help to align all the parts at all the joint areas.
Then proceed to tighten all bolts sequentially.
DO NOT tighten any screw fully and then towards the next one.
This would cause the frame to warp.
If there is still wobbles, loosen the screws and execute this same process.
WARNING!! IF THE TABLE IS NOT STABLE , IT COULD LEAD TO DAMAGING
THE PRODUCT.
Ensure all bolts are fully locked into position.
The table is ready to be used.

This Table can only be used on a flat, level surface.

Page 6 of 7

Page 7 of 7