Miller Edge CPT-210 Assembly Instructions Manual

Model# CPT-210 Sensing Edge

Assembly Instructions

IMPORTANT:

PLEASE ENSURE THAT THE FOLLOWING INSTRUCTIONS ARE FOLLOWED

CPT TECHNOLOGY - RESISTIVE SAFETY EDGES

Components List:
CPT210-K-5

50 ft. - CPT223 extrusion
5 - Wired End Plugs
5 - Non- Terminated End Plugs or Terminated with 8.2k/10k/DC
1 - Tube Vyna Bond Glue

Step 1: Cut the Extrusion

1- Measure the width of the door.
2- Cut the extrusion 1 inch less than the door width.
Note: Ensure that the cut be square and free of rubber fragments.

Step 2: Insert the Blank End Plug and Glue.

1- Insert 50% of the blank or t
2- Apply a continuous bead of Vyna Bond glue ONLY
3- Fully insert plug and hold firmly to fully seat the plug and form an

airtight seal.

4- Use caution, do not allow glue to contact conductive tongue.

Step 3: Insert the Wired End Plug and Glue.

1- Insert 50% of the wired end plug into the extrusion.
2- Apply a continuous bead of Vyna Bond ONLY
3- Fully insert plug and hold firmly to fully seat the plug and form an

airtight seal.

4- Use caution, do not allow glue to contact conductive tongue.

erminated end plug into the extrusion.

around the perimeter.

around the perimeter.

Use Caution:

Do NOT allow glue on

the conductive tongue.

For more information, please visit www.devancocanada.com or call toll free at 855-931-3334

Step 4: Connection Cable

1- Press the connection cable into the groove on the End Plug to direct it

towards the junction box.

Step 5: Wiring Connections

1- Connect black wire from edge sensor to Coil Cord black wire.

Connect white wire from edge sensor to Coil Cord white wire.
Connect Coil Cord wires to Operator’s Safety Reverse input terminals.

NOTE: The Sensing Edge should be checked periodically (at least once per month) for any signs of damage,
cuts, loss of sensitivity or water damage.

Figure A.

Rolling Steel Door

Terminated

End Plug

includes an

8.2K Ohm

Non- Terminated /

Terminated End Plug

monitoring

with 8.2k/10k/DC

resistor

Figure B.

Sectional Door

eeeeeeeeeeeeeeeeeeeeeeeeeeeeee

Junction Box for Sensing Edge

Termination Only

2-Wire

Sensing

Edge

Wired

End Plug

Operator

Connect Coil Cord wires

to Operator’s Safety Reverse

input terminals

eeeeeeeeeeeeeeeeeeeeee

Connect Sensing Edge Output

wires to

Coil Cord wires

NOTE:

An Interface Module (Model EIM-101) is
available for mechanical operators that
utilize a 24 volt control circuit.
Logic operators normally do not require
an Interface Module.

CPT210_Inst_20140822

For more information, please visit www.devancocanada.com or call toll free at 855-931-3334